Stainless OX CNC Router Calibration of Steps/mm in Mach3

How to Calibrate Steps/mm in Mach3 of the DIY CNC Router Stainless OX. Initial setting based on calculation followed by a manual procedure (measure, calibrate, re-measure).
NOTE: Remember, if you have a slave motor on one of the axis you have to copy any calibration data to the slave axis under Motor Tuning.
For more info check: forum.makersup...
To get parts for the Stainless OX check out: makersupplies.dk

[@peterpollard7204]

Thanks again Martin, Got my plates being cut and the price was $330 AUD to be laser cut. will let you know the quality once I get them back.

[@khaledalhalabi9028]

Thank you for this video ❤️

[@adamhaworth6309]

Really helped me thank you 🙏

[@moorthimoorthi3908]

Sir my problem is my machine not home switch setup, your settings is workout ah? Sorry for the my bad english, reply me plzzz sir

[@RicardoMRachel]

Congratulation. Very helpful.

[@1bulldog998]

great video i`am right on the money 200 mm were it was set

[@ronald44181000]

I really appreciate your demonstration as it has cleared up a lot of my confusion. But I tried the Prusa Calculator and I noticed that there is no reference to use with the GT3 Belts. Just to make sure I'm not missing anything. What values should I use for these belts?

[@martinbarfoed5040]

Hi Ronald, As far as I can see you do not need to use one of the presets in Prusa. Just enter the three numbers for Motor Angle (1.8), Belt Pitch (3) and Tooth count (e.g. 20). The pitch for GT3 is 3mm. Hope this will work for you

[@AR_Aero_Engineering]

What is the plate called that you get as the base ?

[@martinbarfoed5040]

Dobyou mean the MDF spoil board?

[@alicante1989]

HI SIR WHEN IM USE '' axis calibration " the steps per unit is "" 5.55221 '''' but when move cnc by g code the machine move very very slowly

[@martinbarfoed5040]

Wow that's not an easy question to help you with. You need to secure that controllers are set correctly and that it's reflected in the controller program. Then you need to do motor tuning (if you are using Mach3) All this must work when you jog the machine before trying to send g-code

[@RGCbaseace]

anyone know how to do this in bcnc ??? mach3 makes it too ez

[@chriskall6276]

And ahhhhh and ahbhhb and ahhhhhhhhhh

[@dipakpatel8780]

Hello sir