Stanadyne injection pump repair video 2 reassembly

[@adamlagace2485]

So where did you get seal kit for pump ?

[@dDayye]

Does the weight cage go back on only a certain way or is it possible to get it 180' wrong or does it matter?

[@dakotak8437]

Any ideas why the pump started working then sat for few months then won't get fuel. Then out of injection line did a few sperts then stopped agen but won't take fuel or pump any ideas

[@matthewlewellen6516]

awesome video, thank you. only thing im thinking is never use teflon tape in a fluid power circuit.

[@lovetofishneosheo1829]

7.29 how did you put the snap ring on the shaft that drives by putting that in first

[@kennethmabus381]

Didn't see you put the head back on pump. I know the C stays on top of the pump gear but does the outer part of the pump ring get held in by the top and that tension pin hold it in place?

[@amir-khanengineer]

Good work

[@tcwaterdrill]

Very good video, thanks.

[@کیوان-ذ5ف]

You're very good anginer

[@jasondecamp4119]

I rebuilt mine and now it does not rev with throtle I put the one piece weight basket in any ideas. Thanks

[@brian6739]

Where did you get the "ball stud" that was broke in part 1?

[@michaeljp86]

It was either amazon or eBay where i found one.

[@bradyandresen7543]

You are not showing the marks for timing on the shaft and the weight cage and timing mark on the ring which is the important things

[@henryhuffman7832]

what was that spray you sprayed on the pump

[@michaeljp86]

Just a thin oil

[@steverobinson6198]

Can't see anything except his hand in the way.

[@mikemackenzie3382]

Practice makes perfect.

[@aliraq4714]

I can't see your hand😡😡😡😡

[@jhosezambrano8136]

😊