Start and shut down the truck mount.wmv

[@sundown798]

Been using this machine for almost 13 years now. Very dependable machine I have put barely anything into put general maintain. Keep a eye on that pesky chemical pump diaphragm too. Been changing out that every few years. Very simple to work on this rig. Always makes me Money and can't remember leaving a job because of failure. It is a GEM.

[@Kai-mj6cm]

😊

[@sundown798]

I did the same thing man cut off the spout at the very beginning of using this rig. Used it to fill powders at first then it became the silencer! Or my 1/1/2 shorty lead hose I use for the stair tool/tile tools ect. Does have a high pitch wine I can't even stand sometimes. Also a must for the overnights when you have the high end condo people are not far away. I Winterize and flush out the main water hose with the funnel as well.

[@pdrknowledgebase]

My advice: Get a funnel with a spout no wider than 1/2" ID at it's widest and cut most of the spout OFF. Kills the whistle, loads the machine a little so it warms up faster, and is handy here in WI for sucking the water out of your pump-out and solution lines in the winter.

[@pdrknowledgebase]

Yes--at full throttle. Sorry to take so long to get back to you.