Steering Rack and Pinion Rebuild Nissan 240sx S13 S14

S13 and S14 Steering Rack and Pinion Rebuild. Thank you Braddah Alex for donating the impact driver!! Let me know if you have any questions. Thanks for watching and Stay Blessed!
Timeline
00:00 Intro
00:12 Remove Steering Rack
02:00 Disassemble Rack
08:06 Rebuild Kit Info (Gate from Rock Auto)
08:30 Replace Rack and Pinion
Songs:
Song: Jarico - Island Music
supported by BackgroundMusicWithoutLimitations
bit.ly/2XoXFnb
"Tokyo Music Walker - Way Home" is under a Creative Commons (CC-BY) license.
www.youtube.co....
Music promoted by BreakingCopyright: bit.ly/way-hom...
Song: Ship Wrek & Zookeepers - Ark [NCS Release]
Music provided by NoCopyrightSounds
Free Download/Stream: ncs.io/ark
Watch: • Ship Wrek & Zookeepers...
#s13 #s14 #240sx #jdm #drift

[@anthonychristina5038]

Thank you for this video.

[@donovanlucibello379]

That was a very well done video, thank you!

[@hersonsegovia2373]

I needed this in my life! Thank you sir!

[@masterofnone1740]

You’re very welcome Brotha Herson! More S13 rebuild videos are coming soon. Enjoy!

[@taylor3014]

That was really helpful thanks heaps!!! Also quite funny near the start reminded me of myself in the garage.

[@masterofnone1740]

Thanks Taylor! I’m glad this video helped.

[@felipefalcon4811]

you saw 240 tony do it first hahahah same procedure! lovely done!!

[@masterofnone1740]

Yes, it is meant to help others. This video has additional information that was not covered in other videos similar to this one. I hope you found it useful.

[@ag.3153]

Informative video. Good job! Thank you!

[@masterofnone1740]

Thanks!

[@jordans4348]

This video is gold.. Thank you Sir!

[@masterofnone1740]

Glad it was helpful!

[@jdub6909]

Nice job!

[@masterofnone1740]

Thank you, J DUB! I’ll be publishing more S13 part rebuilds. Hopefully, these videos help out the S Chassis community.

[@MasonTan27]

Thank you! What is the neutral gear in step 1?

[@masterofnone1740]

Hi Mason. After installing the gear housing, and measure “rack stroke” on both sides of the shaft to be even. Both sides should measure 68.5mm - measuring from the end of the rack to the end of the part where the tie rod end connect.

[@jakel7513]

Did you just hammer out the inner washer that contacts the the inner seal?

[@ag.3153]

No, I utilized a homemade L-shaped puller. Once I removed the inner seal with the puller, the washer (center bushing) easily slides out due to gravity. Ensure not to scratch the inner surface of the rack when extracting the seal.

[@Nolz10]

Great video what are the Metal rings used for that come in the kit?

[@masterofnone1740]

Thanks, Nolz10. The metal rings are the clamps for the steering rack boots.