Awesome. i would wanna see a little bit of everything. 🔥🔥🔥
@tonycrispin3 күн бұрын
Got you!!
@xilusyt57443 күн бұрын
Hell yea this is sick! I wanna see all the nitty gritty stuff with the build! 😎🔥
@tonycrispin3 күн бұрын
😎😎
@garplin3 күн бұрын
everything bro. make it a series. dont be caught slacking. that time gonna flyyy!!
@tonycrispin3 күн бұрын
Ok, will do! Got lots of work to do for sure lol
@7forty13 күн бұрын
I want to see it all! Can't wait for the big turbo K24!
@tonycrispin2 күн бұрын
👀
@PaulsensGarage2 күн бұрын
You and GhettoRig make me want to abandon all of my projects and get a Z to build as a drift car.
@tonycrispin2 күн бұрын
Their good rigs, can’t lie about that!
@monstersquashracing3 күн бұрын
Awesome job man. Film it all Man. Let see this thing come together
@tonycrispin3 күн бұрын
Will do thanks!!
@ua2443 күн бұрын
Good luck with a swap!
@tonycrispin3 күн бұрын
Thank you!!
@sheanherrington20163 күн бұрын
Definitely cut secondary firewall and cut it all the way down !
@tonycrispin3 күн бұрын
All the way to the trans tunnel?! I’ve been looking at it debating how far down to go lol
@sheanherrington20163 күн бұрын
@ yes but it goes down to frame rails i believe.. alec robins and a few others did it to theirs definitely more room to work and look good.. and also love the videos man keep it up 👍🏻
@tonycrispin3 күн бұрын
@ for sure I’ll look into that, I’ve taken a lot of inspiration from Alec’s build! Thanks!!
@JamesJr6753 күн бұрын
its crazy how much of the stock harness there is. i took mine completely out. chassis / motor. and made my own. theres maybe 20 ish wires or so. super bare mini
@tonycrispin3 күн бұрын
That’s the plan! I can’t believe how big and bulky the stock harness is haha
@JamesJr6752 күн бұрын
@ yeah im wrapping up a LS swap. I went arc panel with another relay box to use the holley term x to control the rad fans and trigger the fuel pumps so its less to think about. If i was to do it again id prob just go pdu. From link or something and make it way more simple
@SitTime3 күн бұрын
i have drifting only HR and i know sooner or later i will have to engine swap, i want to see and learn everything needed that V8 swap (im guessing)
@tonycrispin3 күн бұрын
I’ll document as much as I can! I’ll be learning along the way too haha
@Tico_Z3 күн бұрын
also whats the best way to remove those 3 bolts that go on the cat to the headers? thanks
@tonycrispin3 күн бұрын
I talked about it a little in my test pipe video but you can get 1 or two from the bottoms and then long extensions from the top make it pretty easy!