Stuck Oxygen Sensor Removal Tips & Tricks

Watch at proclaimliberty2000 how these tips and tricks can make oxygen sensor removal a lot easier.
CTA Tools 2064 Thin-Wall Oxygen Sensor Socket
www.amazon.com...
Disclaimer:
Under no circumstances will proclaimliberty2000 be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by proclaimliberty2000 or a third party. In no event shall proclaimliberty2000 be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of proclaimliberty2000, it cannot guarantee against improper use or unauthorized modifications of this information. Proclaimliberty2000 assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Proclaimliberty2000 recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of proclaimliberty2000, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not proclaimliberty2000.

[@mlight6275]

Very clear and concise, BONUS PRAISE, I thought your voice overs in THUNDERBIRDS were great inthe original series....Thanks...

[@briandoyle2552]

EXCELLENT VIDEO, GREAT HELP FOR ME!

[@awesomewaffles4605]

Thank you for letting me know about the o2 sensor socket. I thought I was going to have to wrench it. You have saved me much time and frustration!

[@proclaimliberty2000]

👍😃

[@MutsPub]

Very helpful, thank you.

[@cookedmarbles4888]

Mine was on there so tight o2 socket just stretched outward and slipped. Used wrench and it rounded off edges before it budged even an inch, this is with penetration. Will have to get a torch...

[@markroderick3300]

I was always told to use copper never seize on o2 sensors because of higher heat tolernce

[@TerryMorrowSr]

Thank you for the information

[@EBC-k8n]

God bless this man so much. Like 👍

[@joewhatsup]

Thank you sir, great video

[@matttzzz2]

The part I'm struggling with is unplugging the electrical connector, because i can only fit 1 hand under there and its all covered in oil

[@abdiel_NG2000]

put a flat screw driver through one of the gaps on the connector

[@genevatungate1006]

Please redo this video, your emphasis is NOT CORRECT!