Subaru Rear main seal along with Oil separator cover sealed again

Hopefully this was done well to everyone's liking, I know I did not place grease inside the Main seal to keep spring in place, I have never had a problem with that to my knowledge. The oil separator cover looked good so I did not get another, just used my motoseal after I cleaned it up to seal it to the block again. The other smaller cover I replaced the rubber gasket.

[@tedharris6066]

That was a good job Bill, Thanks.😉

[@crazybillsgarage]

Thanks Ted, it was an easier job.

[@corolineharris6832]

This is good, I am in process of doing this to my 2.5 Subie. Thanks Bill.

[@crazybillsgarage]

Coroline from what I know about you, you will do a better job.👍

[@LooneyFarmGuy]

That went better than last time 🤔

[@crazybillsgarage]

It looks better and nothing broke.🎉