Turkish Metal Spinning with John Akkus

John Akkus demonstrates his metal spinning technique. See John and his demonstration live at the Fall 2010 Sugarloaf Craft Festivals in Timonium, MD, Somerset NJ, Oaks, PA, Hartford, CT, Chantilly, VA and the November show in Gaithersburg, MD

[@AlainAngulo-xg7gt]

Excelente trabajo.

[@n2dabloo]

Thank you sir! Very informative.

[@ArnoldsDesign]

@turbotonic27 No explosion, but plates have been known to get thrown from the lathe before the plate is "seated" against the form. I do spinning too, and it's not bad. It's just tricky to get the technique down without the metal wrinkling.

[@walterhebertsilvagonzales232]

Hello, does anyone know web addresses of lathe manufacturers, I would appreciate it.

[@yenersevim990]

Selamünaleyküm cihan usta ben izmirde yasayan metal sivamaciyim orada is durumu nasil calisabilirmiyim.tesekkurler

[@AlainAngulo-xg7gt]

Se puede hacer un tubo de 10mm de diámetro y 12 de largo por el método de repujado le agradezco sus ideas y opinión.Suy cubano y aquí no hay mucha cultura de este trabajo gracias de antemano.

[@PTinvest]

How to calculate sheet metal shape of the projects

[@محمدمحمود-ن1ي7ط]

عمل ممتاز يمكننى تنفيذه بسهولة

[@ercyil7827]

I m not sure, his name is not John Akkus, i think his name is Cihan Akkuş