The first time I've seen someone walk the cup and get silver, usually the travel speed is too slow, but this guy was cranking just making that consistency even more impressive i honestly though they had the camera sped up
@Tigwelding99Ай бұрын
thank you sir
@Jayce.Wolf7875 ай бұрын
awesome video im learning argon welding
@ShainurBegum-mb4co3 ай бұрын
Good job bro
@mgodinez90653 ай бұрын
How many amps did you put the root pass?
@Tigwelding993 ай бұрын
Root gap 3.2-4mm Pipe thik 6-11mm Amp 95-110
@ryry473 ай бұрын
Super slick root 🎉
@Tigwelding993 ай бұрын
thank you
@RezaHermansah6 ай бұрын
Nice video
@Tigwelding996 ай бұрын
Thanks
@Tigwelding998 ай бұрын
thanks everyone 🥰🥰🥰
@dustinpouchot27833 ай бұрын
I have a few setup questions. What acreage were you welding at? What is your purge gas flow rate? What is your torch gas flow rate?
@Tigwelding993 ай бұрын
this is Super duplex - purge gas flow rate 25+ and note: oxygen level should be 0.005 ppm. Torch gas flow rate 15-20 and must be use gas lens body and cup 10-12. Thank you
@dustinpouchot27833 ай бұрын
@@Tigwelding99 can you give any root and hot pass amperage suggestions?
@Tigwelding993 ай бұрын
2" to 6" pipe SDSS Pipe thikness 6 mm to 11 mm Gas flow follow as i given previous Amperage 80 to 110 Root gape 3.2 - 4 mm
@dustinpouchot27833 ай бұрын
@Tigwelding99 thank you so much! I currently work on SDSS so I'm always trying to get better.
@martinbalok4314Ай бұрын
Hi from czech Sir can u show us how to start at bottom section.(please)❤