SUPER MONZA 230

[@mick8989]

Fantastic technology.....love it

[@williamjmansfield8768]

Been enjoying your videos since I came on your site a couple months ago. Old-timer in Florida,USA

[@TheSteelweasel]

Fantastic to have you ..... USA 🇺🇸 🌎 🇺🇲

[@paulhughes8724]

I've just done an RB252 build on a uni case and flange , rayspeed 5 speed , 62/116 sip crank and vape ign and was pleased with everything I used

[@midge225]

So far so good Ste , cant wait to see the final build and test run. Keep on keepin on m8 👍🛵

[@TheCutdown61]

Just installed an AF 5 speed and it required a .5mm shim on the inside of the hub bearing so the layshaft sat deeper in order to get a shim within spec. - only took 3-4 times putting it together and pulling it apart to get it right haha.

[@TheSteelweasel]

Bit drastic ? Hope I have more luck ...... thanks for comment come back any time 🥳

[@martinleech1509]

Hi Steve. I saw you angle grinding the ends of the gear selector forks prior to fitting the pawls. I understand why you did this but was it necessary given that the Uni case has two recesses cast (inside) above and below the rear hub bearing to allow for extra movement? These recesses were added at the request of Ben Kemp to Uni. Thanks Uni.

[@TheSteelweasel]

Yes I know but they don't fit in the holes perfectly and I've had trouble before ..... don't like taking it apart again if I jumps out of 5th pain in the ass .... belt and brasses

[@martinleech1509]

I bet Ben is fuming

[@solesust]

Ride on!

[@richardshipman8399]

there's some €'s in that lot 😯

[@cm-oo1td]

There's lean jetting theres ritch jetting and there's correct jetting 😮 There run in after a hour 😂

[@wayneb251]

If you can't replace Gearbox Endplates SW, why do Casa amongst others sell replacements?😎

[@TheSteelweasel]

Ask casa lambretta ? I always use the original if possible as they are a machined pare........

[@richardfowler6229]

It's supposed to be a great kit. 👍

[@jonathanparker2411]

Weird power curve on these motors. Need the performance tuning exhaust

[@TheSteelweasel]

Don't worry. I was building hand made expansion chambers since 1989

[@TheSteelweasel]

kzbin.info/www/bejne/iKTMn2uiqpx0qsk