Superpro Lift Kit install on 2013 RG Colorado

I'll show you how to install the Superpro Easylift (TRC185LK) onto a 2013 RG Colorado. While I am getting into the suspension, I chose to change out all of the existing rubber bushings on the rear leaf spring suspension as some of them were damaged. I installed Nolathane bushings all round on the rear as well as new Webco shock absorbers for extra travel. Lastly I had a wheel alignment done to complete the install.

[@handymatt9377]

The black spacers were sourced online. Just did a web search.

[@stevendouglas6593]

Nicely done.

[@matiasbosshardt8888]

Good job!

[@anektritrong3026]

Good job

[@handymatt9377]

Thanks, worth the effort

[@peterryan7340]

Would this have been much easier if you used spring compressors?

[@handymatt9377]

Yes, but I don't have a set.

[@freskkookie2107]

Hey mate where’d you get you UCA spacers

[@handymatt9377]

Just Googled. I think PSR do them but I don't think that's where I got mine from.

[@freskkookie2107]

@@handymatt9377 hey mate where did you get longer bolts for your UCA spacers

[@handymatt9377]

@@freskkookie2107 I hate to say it but Supercheap Auto. They have high tensile bolts in a 4 pack (with nuts) on a hanging rack in the stores. From memory they were M8x65mm. I could have also just gone to any bolt/fastener supply place but make sure you get high tensile and not mild steel.

[@iwannacausetrouble2700]

Did you tighten up the thinumebob and the duberflaky

[@handymatt9377]

Of course. But only after I checked the tension on the Fritzenguben.