Suzuki DF140 - how to replace the anodes

[@franb.1159]

Hello, first of all, Thanks a lot for the video, could you please tell what kind of greasw do you put around the anodes? Thanks again

[@smaabaadsnyt-altomsmabadeo9300]

Hi Fran - I use saltwater resistant marine grease. Some would perhaps use siliconebased grease as its also for lubricaring the rubber o-ring. Very often you will see corrosion between the aluminiumparts and thats why I very often use the marine grease. Kind Regards Per

[@franb.1159]

@@smaabaadsnyt-altomsmabadeo9300 thank you very much

[@gregbrock1946]

How many hrs sud this be done..in saltwater

[@jaekimzx708]

There’s lot of corroded build up inside the anode housing. I’m assuming you should clean that out? Do you scrape it or brush with a stiff bristle brush? Also, I’d assume you’ll have to suck it out rather than blow in the corrosion? TIA

[@smaabaadsnyt-altomsmabadeo9300]

Hi - I have removed it with very gentle with a small screwdriver ensuring that nothing gets into the engine

[@vikingooffroad6719]

How many anodes does it have in total for the DF 140 2015 ? where would the others be ?

[@smaabaadsnyt-altomsmabadeo9300]

hi - have a look at the replies/answers from Robert Jordan. I have only replaced the 3 which is on the powerhead. Rds. Per

[@vikingooffroad6719]

@@smaabaadsnyt-altomsmabadeo9300 I looked a bit further I think the 2015 has 5 in total

[@fedeleroby]

can I now the size and pich of extractor bolt?

[@smaabaadsnyt-altomsmabadeo9300]

Hi - its 8 or 10 mm

[@Byang995]

What size is the bolt size you used to back the anodes out with?

[@smaabaadsnyt-altomsmabadeo9300]

Hi, as I remember it it was 10mm

[@thernsa]

Bolt for removal is 10x1.25mm

[@captpepin]

I believe it’s 10mm 1.5 pitch.

[@pedrogonzalez5501]

Hola. Tengo un df70cv del año 2002 cuántos anos lleva y dónde están situados. Gracias

[@smaabaadsnyt-altomsmabadeo9300]

hola - no lo he visto en un df70 pero trato de buscar en www.boats.net repuestos

[@giovannim5101]

Do you run your Df in salt water.?

[@smaabaadsnyt-altomsmabadeo9300]

Yes

[@CaptainBobby74]

How many are there?

[@captaindavidalphonso9701]

Same question that brought me to this video. I have found five so far.

[@captaindavidalphonso9701]

There's three in this video, one on outside of lower unit, and one more under the clamp bracket.

[@alexmccraw129]

@@captaindavidalphonso9701 there are 5 total however the sevice kit does not come with enough anodes or orings in the 100 hour kit

[@RedfishNation]

@@alexmccraw129 Thank you for the reply!

[@arooshka]

@Alex Mccraw Do you happen to have the part# for the other 2 anodes that aren’t in the service kit? Thanks.

[@josemiguelml8658]

Hola buenas tardes Cuantos lleva en el motor el 115hp del 2019 Yo veo cinco tapas en el motor

[@smaabaadsnyt-altomsmabadeo9300]

hola quiero creer 5 piezas

[@josemiguelml8658]

@@smaabaadsnyt-altomsmabadeo9300 ok no tienes tutorial completo para ver donde van Muchas gracias