SVC VS DVC 8-inch subwoofers with Amp Dyno and basic tech chat on cross over points.

[@BasicKustoms]

1 min in and I already liked the video

[@hunkkwoizer6653]

g8 content brother.... subbed!

[@QuintinLourens]

Busy building up the daughters sound in car. She has a polo playa. I opted for the starsound atom 6400.4 to drive 6x9's and mids. For the mono block im going to get her a Starsound 6600.1 Already got the sub, pioneer 12 inch svc sub rated at 500 watt rms. Thats what she wanted, matching wont be crazy off but wont be 100% ideal either. With it being a 4 ohm sub and the amp being so small, amp shouldn't get to hot, and due to car and everything else it should still sound very good i rekon. In the front i have a jbl head unit with jbl mids. Then im running starsound super tweeters, and 2 pioneer 6x9's Will becadding the sub soon when i get the atom monoblock. Wife told me not to go to big in daughters car, but next year im buying an old 2nd hand bakkie. Dan gaan die poppe dans

[@abhishekrajpaul3010]

I would like to know more of the app and the crossover used

[@adrianbailey1487]

Link to that song....

[@nezosgarage-neereshharrich8891]

Gosh, I don't know where I got that track from. Check out DR Rene's mixes. I'm almost sure it's one of his.

[@Jul1zn]

Please can you do a video on crossovers, and slopes

[@MKVally]

Just a suggestion if you able to get your hands on 1, would be nice to see a dyno of a DD RL-SA 500.1 .

[@nezosgarage-neereshharrich8891]

If I ever find one, I certainly will

[@kaldonmecoreddy6666]

Howsit Nezo....just curious on how you ran a 2 ohm load in bridge....previously in my experience I've found...certain 4 ch amps don't really like any lower than a 4 ohm load in bridge. IF you could share some light on the matter it would be appreciated. Thank you

[@nezosgarage-neereshharrich8891]

With this system, I was able to because the impedance raise on the woofer is high. But as I mentioned in the end, the amplifier does heat up a lot more. Also, if you come down on level like I did on the subwoofer volume from the deck, it doesn't straight the amp as much as when you're pushing it at full tilt.

[@kaldonmecoreddy6666]

@@nezosgarage-neereshharrich8891 thank you for the clear and concise explanation 🙏

[@vpowerelectrix998]

Nice vid...but the main question... Is a 500w RMS SVC subwoofer...able to handle the same power as a 500w dvc subwoofer?

[@lanceschouw5276]

In your opinion what is the best SQ loaded sub and amp combo I could get for my Nissan qushqai. It's the family car so I'll have to remove the sub when I need boot space but as a daily I need some base in the car.. Personally. I've only ever heard the DD loaded subs. But is there better out there

[@MrOberya]

That 8 plays nice and clean.....Love the deck!

[@nezosgarage-neereshharrich8891]

It does! It gets pretty loud too.

[@nezosgarage-neereshharrich8891]

It's a great budget combo

[@basserex4991]

@@nezosgarage-neereshharrich8891 Hello! i have bass problems, i fight with this about 4 years on two cars: Mazda 6 and mazda 323f ba. Bass sound like shit, no loud, no feel pressure on body, but only flex car. All audio components ale 100% good. Small voltage drops... Problem going on two amps so its cant be amplifier, its cant be rca wires. Sometimes its play much better, bass softer, and fell more presure, but vibrations on car this same, this same voltage drops, and bass loss after next engine start... Sound like Ground? HU problem signal? I have amps ground (but long, about 1,8 meter per wire) from Lithium yinglong 80ah terminall in trunk, But ground from lithium going from: ALT-> Chasis-> Battery 50mm2 one wire Engine-> CHasis-> Battery , one 50mm2 wire And nearest 80cm per wire 2x 50mm2 wires. Any ideas? :)