SVS Audiophile Happy Hour | 3000 In-Wall Subwoofer Launch Edition

[@oncrx]

3000 Micro sub looks awesome!

[@lucasb2225]

I missed the livestream because i was testing out my new PB16 ultra in my home theater. Looking forward to getting more SVS equipment for my garage and fitness room.

[@danieltorres-qk4fm]

SVS amazing!! I have the PB3000 paired with prime wireless speakers and let me tell you these things are amazing!

[@SVS_Sound]

Great to hear!

[@BoyGenius-1]

Correction: SVS tri-band wireless adapter is perfect for this amplifier. I’m going to use this sub in my LivingRoom setup and have no extra room in my AV cabinet. I’ll be mounting the amp in an adjacent closet (next to stud bay used), wiring speaker wire to the sub and using the wireless adapter for the signal. In fact if you have a wall opposite of the wall you place your sub, why wire all the way the a rack? Wireless adapter would be perfect for these Do-it-yourself applications.

[@Mrfishlou]

'Just finished my basement, all the drywall is up - BAD timing on my part. But not to worry, the trusty old SB13 Ultra will do just fine!

[@digicompme]

The SVS speakers are much easier to setup. I hope soon all of them are wireless/bluetooth enabled to make things even easier to setup.

[@rjw705]

When will the next happy hour be? Always look forward to it!

[@waqasahmad9917]

I have Anthem AVM 90 with 4 individual sub inputs.. Does SVS amplifier offer separate dual output to configure dual subs?

[@sammy10001]

Svs, can you run this in wall sub in high level? Run it high level to another speaker, such as a center channel speaker to make it a full range capability. Can this be done with spade connector speaker wire?

[@SVS_Sound]

The signal needs to be routed through the 3000 In-Wall amplifier, which can only accept a line-level signal. This could be done with a line level signal from the AVR pre-out for the center channel. With that said, it’s not a good idea, because it would require the center channel to be set to Large / Full-Band in order to send all the bass content for that channel to the 3000 In-Wall amplifier. And setting the center channel to Large/ Full-Band will create undo stress on the center channel mid-bass drivers, which will increase distortion, could damage them at high playback levels and also will consume more power from the AVR. As always, it’s best to set all speakers to Small with an appropriate and safe crossover frequency and then route all speaker channel bass and the LFE .1 channel to the subwoofer.