switching camshafts on a 360 MOPAR and easy centerline method of degreeing

[@JustMoparJoe]

Very good parts and process. You made a mega gain in cam there. I’m absolutely scared to use a new flat tappet comp cam and lifter set. I used an Isky cam with similar to your crower. Had great results!

[@GAMALA194]

thank you so much for watching i have a set of X heads im putting on

[@tomstrum6259]

Real Nice cam selection there !! Thx for Clearly showing the cam Degree install/Check process.....With all the Flat tappet cam & Lifter Break-in Fail reports going on, Did you verify & Measure the new cam's Lobe Taper & lifter Face Radius measurements ? Really like the heavy Moly lube application.....I don't Moly up cam Journals bearings or any Bearings as that could negatively Interfere with pressurized Oiling.....I do Moly up the Distributor drive gear though.....Thx for video...

[@GAMALA194]

i didnt go to that extent on the taper and radius, making sure your cam is centered properly is a must as gears and chains could be defective thanks for watching this video i appreciate you,

[@Anthony-nw5zv]

😊 good video 😊

[@GAMALA194]

Thanks for watching this video I appreciate you

[@edsmachine93]

Nice job. Nice camshaft, they use to say Crower is the name for Power. Thanks for sharing. I just subscribed to your channel. Take care, Ed.

[@GAMALA194]

Thank you for watching this video I appreciate you. I just watched your video on the 408 mopar build and I also subscribed to your channel