SWT - Choke Manifold

The choke manifold is used to control the fluid from the well by reducing the flowing pressure and by achieving a constant flow rate before the fluid enters the processing equipment on the surface.

[@Maxwello11]

Amazing stuff, keep it up

[@kwstn]

Thanks a lot ❤️

[@francktchibinda9908]

Very interesting.

[@kwstn]

Glad you think so!

[@aidar2140]

we can adjust the choke size (adjustable choke) to make it the same as on the well?

[@kwstn]

Yes, you can adjust the choke size on an adjustable choke to match the choke size on the well. This will help to ensure that the flow rate of fluid or gas through the choke is consistent with the flow rate through the well. However, it is important to note that there are a number of factors that can affect the flow rate through a choke, including the type of choke, the fluid or gas being choked, and the pressure differential across the choke. As a result, it may be necessary to make some adjustments to the choke size in order to achieve the desired flow rate.

[@MrX3room]

Much appreciated!

[@kwstn]

Thank you 👋🏻

[@aidar2140]

can we install the same choke bean (fixed choke) size that is on the well (same wellhead choke size)?

[@kwstn]

Yes, you can install the same choke bean (fixed choke) size that is on the well (same wellhead choke size). This is a common practice, and it can be done without any problems. However, there are a few things to keep in mind: - Make sure that the choke bean is compatible with the well. The choke bean should be made of the same material as the wellhead choke and should have the same orifice size. - Install the choke bean carefully. The choke bean should be installed so that it is flush with the wellhead choke. Do not overtighten the choke bean, as this could damage the wellhead choke. - Test the choke bean after installation. Make sure that the choke bean is functioning properly and that there are no leaks.