SXTH Element AV6 Blowoff Valve | Install and Sound Clips |

[@WattAve]

Anyone looking to purchase, make sure to keep in mind you’re gonna need to plug up the BPV hole that is now left open because of the vacuum hose removal. I had bought the plug SE offers without realizing it’s only intended for their own intake kit. For obvious reasons, it didn’t fit my AEM intake. As of right now, about an 1 post-installation, I have it covered up with multi-layers of duct tape and hope it’ll hold until I find a permanent solution.

[@mikiabon6029]

I love that you guys embroidered the N badge

[@thaddeusjackson6440]

So am I the only one to notice there was a completely different intake on the car at the end? That skips the part about capping the intake tube with a 7/8 rubber chair leg cap.

[@originalmusic401]

true lol

[@Jesuswalks14]

Do you have a video on the 2.5T k5 gt BOV

[@Kaged_vn]

Can you use the oem hardware to screw it back down or do we gotta use the one you supplied with it.?

[@johnnyturbo8460]

Do you all have a video on how to install your Alcantara shifter/shift boot in cars with the DCT? How do you remove the factory shifter/leather boot and then install yours?

[@RubenPerez-bq8po]

Would it sound the same for a Kia stinger?

[@mmoplayerful1]

Love the sound, I’m gonna get one for my N. I have the Injen intake and it seems to work well. A lot of turbo flutter. Is that normal?

[@STLSweg]

My ES flutter a lot in lower gears / rpm

[@jaimemejia8784]

Do you need to upgrade the solenoid after installing the BOV?

[@treazure]

Doesn't turbo flutter mean it's ruining your turbo? Is that a fake "flutter" from the AV6?

[@hardyboylifestyle]

I like it. Sounds good.

[@bryanechevarria-j1q]

just a question are u venting to atmosphere and blocked off the blow off return hose on the intake and also is there anything on the blow off valve 1.6t smart stream that needs to be adjusted or is adjustable

[@bryanechevarria-j1q]

I’m not making over 10 pounds of boost. I was averaging 14.

[@ZackZaqZakXah]

What do you with the hole that's left from the factory air intake tube?

[@ZackZaqZakXah]

@Austin Sakser can you send the link again? It was removed by KZbin

[@blakeyboyvidz4576]

​@sak2511 what's the link?

[@ZackZaqZakXah]

@@blakeyboyvidz4576 get the 1 3/8 size

[@topherrinklin8746]

Thanks for the video! I installed my SXTH element BOV today on the stock air intake and had to use electrical tape to close of the hole where the recirc valve was attaching to the intake. I’m not getting any turbo flutter like you but I do have a small woosh in high rpms. How would I be able to get the flutter?

[@aquaisuseful682]

AEM intake is what my N runs. Omg so much STUTUTUTU. You’ll love the flutter

[@-Ncrypt]

You should look up what turbo flutter is. It may sound cool as hell, but it's not good for the turbo or the engine.

[@jeremyhenry3126]

@@-Ncrypt When the compressed air has nowhere to go, it causes the turbo rotational speed to rapidly drop, and attempts to push against the wheel. This can cause premature wear on your turbo, however closed throttle flutter on modern turbochargers is unlikely to cause a noticeable drop in turbocharger lifespan

[@bowieystriezand]

So when you take off the hose you say you won’t need it. Is there a reason why? Are we capping the intake ?

[@FreshEntyce]

I was thinking the same

[@gustavopolanco6925]

Does this fit a hyundai sonata N line???

[@thehondarider5607]

Is that with the factory tube that the blow off valve mounts to or and aftermarket that comes with the uprgraded inter cooler kit

[@roberthinze2425]

Will there be an install video for the stuffed turbo?

[@calebj1.6]

Why do i hear some flutter? Faulty BOV?

[@axelpena8561]

Where am I supposed to connect the black hose

[@bushnellmartin501]

the bypass hose? if so, you dont. They sell a BPV plug for the intake that's like 10 bucks

[@NORBCREW]

Is that turbo flutter coming from the bov as well? Or is that specific to your N?

[@geraldgoodiii6993]

Nope. I have the CF intake u saw at the end .. stock BOV/recirc valve .. same flutter sound. Not as crisp and loud if a PSSSSST I highly recommend the carbon fiber intake with that air box. It’s great and looks so gorgeous

[@NORBCREW]

I have a 1.6t forte, that’s why I ask

[@thegirthquake8574]

@@NORBCREW IMO the best BOV for the Forte GT is the Boomba one. It's just a big ol' hotboy "FSSSSST"

[@calebj1.6]

If your BOV was working you wouldn't hear any flutter

[@KC-bj6cp]

Got mine 2 days ago. Tried to install but could not get that large piece of hose off. How did you get your hose piece off? Also once I do get that hose off, what goes over the connection on the intake hose by the air filter box? You dont show that in the video.

[@dominicjohnson5756]

Will this work on the DCT VN?

[@Dutch75]

Installed on my DCT and works great. Bitch of an install on the DCT, not much space to work with.

[@dominicjohnson5756]

@@Dutch75 well as long as it fits that was my only concern, I most likely won’t be doing the install do to the other parts I’m waiting on from SixthElement to release for the DCT. Thanks for the info 👍🏾

[@kaoticfahid2487]

Will this work for the 2022 kia sorrentos turbo

[@GForceGames1]

When will these be available? They're sold out.

[@maoinc13]

Would this affect the car warranty!?

[@nickzane4406]

Yes I believe it does void it

[@BossArchosRS]

Is this installation pretty similar for the 1.6t's?

[@Tyson_mcnuggets]

Is the turbo flutter bad for the turbo on the n because of the twin scroll?

[@AdrienKooyman]

yes turbo flutter or "compressor surge" is really bad for turbos. The fan blades are literally chopping the back pressure air as it makes it's way past the turbo in the opposite direction. Bad because that puts an immense amount of friction and stress on the turbo.

[@WhosBurstt]

Is there a tune on this?

[@ivanayy5432]

This fits on the new 2022 Elantra N right?

[@jetomco4709]

Yes

[@jakepeterson1706]

I have heard that adding a BOV can cause turbo lag is this true?

[@daboy5252]

is this applicable to 2019 rspec?

[@karbonkevin919]

Stock turbo?

[@40rtyp]

Wait, so you guys sell the most expensive BOV for Hyundai/ Kia cars yet you can't bother to include a rubber gasket for it? Your competitor(GFB) is $100 cheaper and provides that gasket. I get you guys do great stuff for Hyundai/Kia platforms and have the quality but really? Skimp on things like that while charging $100 more?

[@PhoneticIHype]

good looks bro, i love SXTH but ill look elsewhere for this product

[@noahreed3202]

Works for r spec?

[@newreformationapologetics4953]

Does anyone know if the intake and bov voids rhe warranty for a new N?

[@thaddeusjackson6440]

Intake no, BOV yes.

[@EMJ_USPSA]

@@thaddeusjackson6440 Did the dealer tell you this?

[@thegirthquake8574]

@@EMJ_USPSA Unless your mod breaks something or changes a fundamental function of the vehicle (transmission or engine swap for example) they can't void your warranty for a mod. And even then, they'd have to prove your mod caused the damage.

[@vito_413]

Will this fit a 1.6t Elantra N-Line? Will this void the warranty? Thank you.

[@theflukey4114]

Yes, i have one on my N line too, and no, it won't void warranty

[@MrTherandomvidsguy]

Anything you change in the engine will void the warranty. Try to ask the warranty department and see if they can install it instead to keep the warranty.

[@sa1nts128]

Does this void warranty?

[@someguy4505]

Anyone else just think that the sound it makes is kinda irritating? It sounds like something is broken.

[@beyza64js]

Will it void my warranty? Can I change it back

[@karbonkevin919]

Yes u can change it back

[@geraldgoodiii6993]

U can’t “void” a warranty. BUT if an aftermarket part causes a problem they can deny a warranty claim. BOV is one of those to watch out for.. And tunes. They’re super fast and easy to swap out. 30 mins tops

[@MickiDracing]

$220usd BOV and they won't even supply a new oem seal with it, what a joke. You have to pluck your old seal out of your factory unit to save a few bucks (for their company). I have bought SXTH products and they are cheap, poorly designed and terrible quality. Their after sales support is rubbish too when, not if, you have an issue with one of their parts. I will never buy another one of their parts again.

[@jakereynolds1309]

Had the complete opposite of everything you've listed. I can understand about the gasket and that portion makes sense. Everything else just makes you sound like a bitter person as you gave no indication of the products you purchased from them and the issues you had with said products. I've received nothing but quality parts, the one time I did have an issue. It was resolved within days, sxth sent me the same part I ordered before receiving my defective part back. They sent a shipping label and told me to return as soon as i got the time. I've always gotten great feedback from Mark and Tanner and they have always answered promptly. Even on the weekend they were responding to me quickly. Show me some proof and you'll have a leg to stand on.. till then I call bullshit on everything you said.

[@davidlouden6046]

The intake I picked up from them was awesome, sure it took a month to arrive, but what doesn’t with the manufacturing delays from COVID... it was very well built when it finally showed up, they’ll definitely have my business again.

[@btw8775]

You sound Bitter TBH. They’re one of the only companies pumping out quality products for our cars right now. I nor the other 15 people in my group have had any issues with products or customer service.

[@MickiDracing]

@@btw8775 Jeez, another one. You aren't really saying anything meaningful other than that you and your "group of 15" haven't had any issues personally. Good for you. Obviously if I've had major issues with their products, and I have bought multiple, and their customer service then I'm not going to have a high opinion of the company. The advertisement for this product popped up in my feed and I felt the need to voice my opinion on the fact that they require you to reuse a cheap seal from your OEM part rather than pay the 30 cents to supply a new one. It isn't a cheap part and having to reuse a cheap seal on it is a fucking ripoff! The fact that you seem unwilling to accept that customers other than yourself have had issues with SXTH products and customer service, and that anyone who does not have a high opinion of the company is just "bitter" makes you sound like an ignorant fanboy

[@myusernameisthisduh]

@@MickiDracing lmao dude you're funny

[@suttonblystone7635]

does this work with a 2022 hyundai elantra N-Line?