Taco Tunerversity - Updating Haltech IC-7 for use with NSP Software

[@renob98362]

Ooh, fancy. I'll have to check out the new functions

[@existentialrap521]

Good stuff, bro. Didn't know car tuning was this complicated lmao.

[@WT4T]

That's just updating software!

[@andersonruysam7315]

did you connec the dash to the ecu via printer-type connector?

[@WT4T]

No, dash connects via canbus, 2 wires.

[@Cvekawd]

Thank you so much for posting this. Any chance you could help me out with getting my zestek to communicate with the haltech canbus? I recently updated my ic7 and elite 2500. So I'm not sure if everything is playing nice.

[@WT4T]

Unfortunately I don't have any experience with the Zestek stuff and haltech at all.

[@regularguy8592]

I just updated my ic7 to nsp a couple days ago and before doing it I had a screen on the ic7 that shows what is going on with the pd16 and I had this screen even though I have not installed the pd16 yet. My question is what do I have to do to get this screen to show back up or will it show up automatically when I do install the pd16?

[@WT4T]

You can load additional pages through the nsp software. But I don't think that the screen is automatically populated anymore

[@regularguy8592]

@@WT4T yes I realize that but that screen is not in the ones available

[@luissoto1205]

Can you help me set up the fuel level ?

[@WT4T]

Yes sir, email [e-mail] with your setup and exactly what you're trying to do

[@luissoto1205]

@@WT4T sent

[@peopleschampgarage7869]

I feel like Haltech bait and switched me. It's not easy for me, I have elite 1500 & ic7, & wideband and their sensors and there are bugs everywhere and nothing just works

[@WT4T]

Send me an email. I work with tons of haltechs and don't have that issue generally. [e-mail]