NEW 2023 Microwave Blind Spot System By TadiBrothers

[@rightright6582]

i did not see a real life test, could u do one in the future, thanks

[@whittywillshine]

Will this work on metal bumpers? 1969 Oldsmobile 442

[@petesera3091]

So you would need to mount the radars outside the vehicle and run the wires to the front and install the lights somewhere on the door panels? Doesnt look like the harness is long enough to accomplish this, do you sell extention wires?

[@kiesha104]

Do these work behing a fiberglass bumper?? IE C3 corvette...

[@ot2325]

Is it 24 hz or 77 hz?

[@sanghyunlee809]

The harness indicator components are both female where the indicator extension components are both female as well therefore 2 adaptors with male components at both ends is needed otherwise a replacement of the harness is required to resolve the issue Be sure to include the pictures we took of the problem & that should be clearly understood altogether

[@wanderpete9904]

I installed this system. I noticed when changing lane on the left it makes a beep and flashing led lights while a vehicle is approching which is a cool feature but if i change lane on the right with indicators ON it does not beep and flash the led lights when a vehicle approches , does this feature only occurs on one side?

[@Tadibrothers]

If you purchased this system from us, it should beep on both sides. There might be something with the trigger wires that was not connected properly. Please call our service department tomorrow and they will help find the problem.

[@KaushikThakkar]

Do you have a video on how to install this on the car. I have a Prius prime 2017

[@Tadibrothers]

We’re working on getting a few videos onto the channel of how it is installed in sedans, we will try to get a Prius in there as well.

[@jefflindamood9050]

does it go through metal, have a metal truck and bumper

[@Tadibrothers]

Hi, it will not go through metal but you in that case you would skip using the bumper and put it on the quarter panel

[@johnformes7448]

How/where do you mount the lights?

[@Tadibrothers]

The back of the LED indicator has 3m tape. We have seen people also use Velcro and it comes out very nice 😊

[@kellynelson4733]

Assuming you are talking about plastic bumpers. Will this work on a vehicle with a metal bumper?

[@Tadibrothers]

Yes, you can also put it on the side panel of the vehicle BEFORE the bumper

[@BillRatliffIV]

@@Tadibrothers ​​So if I have a Ranch Hand steel bumper on my truck, I would need to mount inside the panel toward the rear of the truck bed, are you saying it will still work through the metal truck bed side panel?

[@ardoholt2063]

I want to mount this on my motorhome, it is 40ft long . the connections don't look to be long enough to reach. How can this item be used on a motorhome?

[@BloomfieldProductions]

Extend the wires using solder

[@waynespicer89]

Price ?

[@Tadibrothers]

Hi, its $499.99