Talaria Sting R MX4 temp sensor/encoder replacement and calibration

[@JoshuaToal-hz9mt]

How do I calibrate the hall sensor on the original talaria sting?

[@TwoThreadsAhead]

Very informative and helpful video! Also likely an eye opener and note worthy consideration for anyone thinking about buying one.

[@toddbraun]

I am getting a reading on my EBMX controller of -182 degrees. Is this an indication of a temp sensor problem?

[@pivkaaa]

Funny, I got the same motor and bike and the sensor looks different.

[@LuckyO97]

So I got the mx4 from you guys, does this happen a lot? And is this bike already messed up or are you just showing how to?

[@Idgaf69]

Good question lol

[@pivkaaa]

Does someone know where is the "match" option on the L1E?

[@kevinwiebe6846]

Where can I find this part?

[@bundy9026]

You guys should do Sur Ron hall sensor next

[@vbrxd8822]

My sting mx-3 just thrown up the same code is it easier just to replace the full temp sensor?

[@lunacyclerepair]

It is easier to do this if its just a pinched wire..if its not a pinched wire then replacing the temp sensor will be the next try.

[@igrik4530]

​@@lunacyclerepair Hi dear, i have the TALARIA MX3 Street Legal (TL3000) and has this problem : after a little fall the speed indication on the Displays show the speed with litlle delay, i can start rolling 2-3 km/h but its shows 0 km/h after i get faster its start to shows the speed indication with delay, what can be the reason and how to fix that ? i also have this Match setting but after i start matching it shows me matching fail after 30 seconds

[@SonnyYoung-s3s]

I have error code 00 anyone got an idea how to solve this problem

[@skykr2932]

Great video but would love to see how to do this on the TL3000 as the hull sensor is a bit different and is not as modular than the TL4000.

[@JoshuaToal-hz9mt]

Hi mate did you ever find out how to do this on the original talaria? I would love to no how to calibrate it!

[@skykr2932]

@JoshuaToal-hz9mt nah mate had to replace the full motor because my sensor was cracked and I could not get the new sensor perfectly aligned