TANGLED on the start! | 2021 Quadcross NW Washougal | Production A | Round 11 Moto 1

[@corygreen7148]

That was a long gate. I heard people back off the throttle

[@AustinRohr]

No kidding! I think that's why things got sideways. People started letting off right when the gate dropped and then everyone suddenly had to pin it off the bottom.

[@Factory43R]

Did those nerf bars bolt right up or did you have to do custom drilling?

[@AustinRohr]

You do have to drill one hole for the peg per the instructions from factory 43, but other than that they bolt right up very easily.

[@Factory43R]

Does it say what size hole to drill? I just got mine in the mail today, haven’t opened the box yet.

[@AustinRohr]

@@Factory43R I'm almost certain the instructions say what size to use. If not, you'd just need to measure the size of the bolt to get the correct bit size. But again, they should say what to use.

[@Factory43R]

@@AustinRohr so I got everything installed, just need to do the drilling. Not sure where to drill exactly and what is the point? It doesn’t really say on instructions. So confused!

[@NoahMazraani]

It looked like you were going a million miles an hour up horsepower hill!

[@AustinRohr]

I gave it all I had! Just found a good drive out of that corner and put the power to the ground.