TC 105 Review Part One

[@cemaa4338]

Thanks for the review. Affected my pick criteria.

[@nickclarke587]

That is £50 in the UK, I can 3D print a much stronger one for about £2 including blade and bolts. In fact I think that can be today's project...

[@davaoshipmodeller]

Is that the Cutter you purchased from the US ? I like the Comparison between those both Choppers . Btw if I cut thicker Wood I cut it from 2 or 4 sides that makes the Job easier .

[@woodgatewoodenkits1477]

Thanks for the comment. No it isn't the one from the US you will have to wait for a review of that one. Cutting from more than one side would be helpful but as I said if the section is getting too big you should probably use you hobby saw.

[@jolid9373]

To be fair about it the maker states that soft woods like balsa , plastics, card can be cut. It does not claim to be able to cut hardwoods which was quite evident by the force you were exerting on the cutter lever.

[@OP-1000]

I think you will be better of with a miter shear.

[@markmcdowell231]

micro mark chopper is all steel but it dose cost $ 45.00 . on u tube a guy shows you how to make a chopper out of wood I worked in plastics factory that is poor plastics.or to much heat on the part.