I think this is the only video on youtube with a repair guide for tilt cylinders. Thanks!!!
@freedomrest Жыл бұрын
Great vid, THX !!!! In some cases (such as my TCM) the rear pin can be left in place allowing work to be completed without removal of cylinder and fighting it out on a workbench. If not able to leave in place, loosening all pertaining threaded connections (spanner nut, allen set screw etc) before removal will help tremendously. As far as purchasing a lot of tools, many local parts stores rent the tools needed (slide hammer and such) basically free for instance O'Reilly's allows a purchase offering a complete refund if returned within 48 hours. Also If the pins are just too difficult to hammer out, a little torch heat goes a long way but spraying with a good penetrant a day or so ahead of work will also make life easier.
@MannicxАй бұрын
Nice, good idea to find a vise and a workbench to make your life easier 😊
@mattsws3 жыл бұрын
Rebuilding a hydraulic cylinder on a folding plastic table…. Hardcore! Love the video! Keep up the good work!!
@mikebingham14542 жыл бұрын
I would for sure invest in building a work bench
@mikebingham14542 жыл бұрын
or at least place the part being hit over the corner leg area so you don't have as much rebound.
@boogalooter8 ай бұрын
A sturdy work bench seems a good investment.
@slowbimmer2 жыл бұрын
First time working on a hydraulic system and this gave me a pretty good idea of what to do. Made doing my tikt cylinder a lot less of a head ache. For the sliding holders I would recommend putting some grease of some kind before hammering it in. Allowed to litterally slide mine in and turn it no problem. Thank you!
@Petesworkshop2225 Жыл бұрын
Good work. Tough job.
@jaspereerdekens31022 жыл бұрын
When you reinstall the cylinder, does the air bleed automatically? Ps: thanks for your video, very interesting
@SteveRivett2 жыл бұрын
you will need to tilt the cylinder back and forth a few times to get the air out and then it will work fine
@multipurposeyuh81092 ай бұрын
I installed back the cylinders and connected the lines back but now none of the lift controls work ? Is there a main valve where you can bleed out the air ?
@stephencavuoti60142 жыл бұрын
Great job !
@SuperMonavie2 жыл бұрын
What king of hydraulic fluid does it use?
@SteveRivett2 жыл бұрын
Hi Cesar, I cover the fluid selection in this video: kzbin.info/www/bejne/h3zJgYuwp81kntU