Techniques for Overcoming / Repairing the Honda Beat PGM Fi, Esp Brebet Injection when on initialgas

Causes and Techniques How to overcome, repair or eliminate the Honda Beat PGM FI motorbike, esp the injection that is complicated when on the middle and top prefix gas or full gas.
The steps we have to take are as follows: Check the wind and slow settings and make sure it's clean. 2. Check the air filter, maybe it's dirty. 3. Check the material for the charging cable from the spool, make sure there is current and check the cable near the rear engine. 4. check the spark plug and choke the spark plug. 5. Slide the TPS sensor up or down according to the video and look for the right settings while the engine is turned on. 6. Check the gasoline output from the fuel pump or the rotation, make sure it is heavy when the contact is on, check the injector and 6. Reset the ecm using the manual.
Thank you very much to all the viewers and subscribers, I hope the knowledge is beneficial.
Please subscribe @ibotmotorchannel6334
If you have any questions, please write in the comments column.
Thank you very much.

[@KingsMajorian04]

Like 1 Terima kasih ilmunya Sangat bermanfaat sekali 🙏 Sampai ketemu di tutorial terbarunya

[@ibotmotorchannel6334]

teima kasih banyak

[@tukangserpis6587]

oke nyimak gan 🙏

[@ibotmotorchannel6334]

trima kasih banyak

[@hendrangab]

Terimkasih kawan semoga bermanfaat sukes sellu kawan

[@ibotmotorchannel6334]

terima kasih banyak

[@naylaranuchannel7651]

terima kasih atas tutorial Cara Atasi Motor Honda Beat Fi,Esp Injeksi Yang Brebet Saat Di Gas Awal,Tengah,Dan Full Gas

[@ibotmotorchannel6334]

sama sma mudahan bermanfaat

[@muhammadyakub13]

Seputar dunia motor

[@ibotmotorchannel6334]

eemoga bisa bermanfaat

[@halwahanif]

Waduh ne pnyakit motor saya pak brebet klo jln terima kasih pak sangat bermanfaat sekali

[@ibotmotorchannel6334]

ya trima kasih semoga teratasi