I just purchased a 475A with the DM 44 option. ($25.00) More or less had to use control cleaner to bring it back to life and as far as I can tell that was the only thing wrong with it. It appears to have been serviced in the last 15-20 years because it's still very close to "spec". However I still need to check the power supply for ripple etc.. Very useful tips in the video, thanks.
@ZenwizardStudios Жыл бұрын
Thanks!, glad the videos helped. On ALL 475 units there are 15 transistors that will require replacement most on the trigger board some on the main board. More info on the fault can be found here - kzbin.info/www/bejne/nXa7ioWGg9Sbr6M Zen
@jimbert502 жыл бұрын
I would like to see a calibration video for a 2465, especially the horizontal sweep cals.
@ZenwizardStudios2 жыл бұрын
I do plan on making a video on this one but I need a 2465 for the lab to put in front of the lens.
@jimbert502 жыл бұрын
@@ZenwizardStudios I would be happy to lend you mine, but shipping would be a pain. I'm in USA; not how far away you are. I calibrated mine and it seems good, but I'm new to this and don't have the best calibration equipment for it and what I have is not Tektronix. I made do with a Juntek PSG9080 waveform generator and a cheap square wave generator for the higher frequencies. My DMM was more than adequate though.
@davesdigitaldomain2 жыл бұрын
when doing the geometry adjustments, is it possible to use a square wave from a signal generator instead of using a time mark generator? I have a signal generator with the rise and fall time of 4 ns would that be adequate?
@ZenwizardStudios2 жыл бұрын
It might be the critical parameter is a straight line. So any straight line should work.
@hkhjg17342 жыл бұрын
I have a 2445 scope where the text is slightly offset from where it should be (top text little higher and bottom text a little lower). Does anyone know if this is something that calibration fixes or is this indicative of a bigger issue?
@ZenwizardStudios2 жыл бұрын
I will check the service manual but I think there are position controls adjusted during the alignment process at least there are on the 7000 series. Is the wave form compressed or expanded i would expect a slight expansion. at all when looking at a squairwave? This might indicate a vertical center issue as well the amp and the tube are miss aligned but if it is only off slightly I would expect alignment/adjustment not a major issue with the vert amp