TEVO Michelangelo XBOX ONE power supply upgrade and fan upgrades.

In this video I am going further where I left off with the dual power supply after heated bed upgrade, now I take those power supplies out and use a XBOX ONE power supply. Wiring: i.imgur.com/wU...
30mm to 40mm fan adapter for extruder:
www.thingivers...

[@mikesnapper9001]

Very nice video. I am going to be chaning the fans myself, since they are so damn loud. Did you have to take apart the extruder head to install the extruder fan, or did you managed to do it with it attached to the printer, and just unscrewing the old fan and screwing the new one in?

[@NoMercy1900]

You can remove the extruder fan without dis-ambling the extruder head, I can't remember exactly but if the removing the screws wont work, remove the shield.

[@mikesnapper9001]

@@NoMercy1900 I managed to change the fans without any problems thanks to your video. The printer is so much more quiet now, it's great. I also checked the power source inside and mine is 7A as well. Have you considered adding an inductive probe for automatic bed leveling? After adding heated bed and changing the shitty fans for better ones, the automatic bed leveling is pretty much the only other thing this printer is missing.

[@lajulasse4332]

Mike Snapper I’d like to this as well, which fans exactly did you replace? The smallest one is obviously the loudest but I was wondering if replacing the two lateral ones on the head was also worth it.

[@yu2ba]

Do you Change the TMC-Driver on this Michelangelo ?

[@NoMercy1900]

Ooops I missed this, KZbin didn't warn me about your comment, no I did not change the drivers.