The aqua scooter AS400 has been restored.

[@shameelahyassim2155]

where did you find the carburetor of is there a cross match.

[@JohnSmith-kv6xe]

And what is in the end? Good job but seems to be it has not started finally )

[@KOISAN7]

After replacing the electrical parts with CDI, it started to work, but most of the parts had to be replaced with AS600, AS400 will not work, most of the coils are dead, and the carburetor cannot be serviced. It does not work unless the AS600 parts are installed.

[@KOISAN7]

I searched in China for a point-type electrical component with an outer diameter of 80mm, but I couldn't find it. The replacement parts are a fuel tank, CDI, carburetor, and 3 cast parts, which cannot be said to be AS400.

[@guillremogarcia6823]

Nice work how's it run I'm disassembling one now it's was running good but I went to started earlier today but no spark and realized water got in the coil

[@KOISAN7]

The AS400 type has a dead coil, I searched for an electrical component with a diameter of 80 mm in China, but it was not found, and when I try to repair the as400, it is almost necessary to replace it with an as600 part.

[@akonvisher]

Greay job!

[@KOISAN7]

Rather than repairing AS450, the job is actually porting parts from AS600 and AS650, and it cannot be repaired with only original AS450 parts.

[@shameelahyassim2155]

how do I listen to you in english

[@KOISAN7]

I'm Japanese, so I'm posting in Japanese.

[@shameelahyassim2155]

Can someone pose a picture how the hoses are connected. I have a As 450, service it attempted to start but got flooded. Have the CDI upgraded and spark is coming out of the plug. want to start but I can't my finger on it. need help. this thing is busting my chops to start. help

[@KOISAN7]

To repair this aircraft, I replaced the AS600's CDI, the AS650's carburetor, accelerator, handle, and carb mounting parts.If you have a lot of used parts, you can proceed, but it is not a work that involves buying parts.