The Complete guide to replace every bushing in your RSX!

Sergmotive Garage products!
sergmotivegara...
Get your kit here!
hardraceusa.co...

[@Trash-horse]

For the rear trailing arm, you just bend the rubber in and tape it before pressing it in. And for you guys with a 2005-06 Integra typeS, the front lower ball joints are the 43mm ones with the M14 ball stud and not the usual 39mm M12 ball stud. Great video, mate. Keep it up.

[@Trash-horse]

I used the same Hardrace bush kit as in the video, hr6758. The part number for the standard replacement ball joints for the 05-06 dc5 typeS is hr8796. The 05-06 typeS roll center adjusting balljoints part number is hr6878

[@happytadaa]

Was always confuzzled about finding bushing for the rear trailing arms. Cheers man!

[@egyptsteel8549]

I remember when I did mine, it was extremely painful. Lol 😂

[@jp554731]

Thanks, gave some good pointers for me to install my Mugen bushings.

[@diego_blackstar3709]

Awesome video, im deciding if putting these on my 2005 RSX-S or going with the Poly bushings... just dont decide... I want great and firm handling but without sacrificing too much softness. But Poly says that too...

[@Straightep3]

Thanks for the video brother, huge help 👍🏻

[@richardm3946]

Great video. Question about re-using the wheel studs. Could you press & Loctite 660 them in ?

[@FinessedIt]

🤙 Always Making 🔥 Videos! Good job Bro!

[@SERGMOTIVEGARAGE]

Appreciate it!

[@jeremysantos4753]

Nice video man, clean car

[@macslate]

“Desperate”. 😂 👍

[@MrDIJEN15]

No discount code? Trying to buy

[@yaggs8941]

Which distributor did u buy this set from?

[@SERGMOTIVEGARAGE]

Got these from hardrace direct, but had to wait about 2 months

[@itsracer7495]

It’s painful and costly , done the whole car twice , first time with all poly second time with all pillow ball🤦‍♂️