The Metmo Pocket Driver - It’s beautiful

[@two-four-five_trioxin124]

I also own the Stainless Steel MetMo pocket driver. I did not like how the drive handle swings around without some resistance, so I purchased a bag of 100 M6 Stainless Steel ultra thin flat washers 6x10x0.2mm off Amazon for $3.78. Remove the two screws holding the drive handle on and insert two of these washers between the body and the drive handle on both sides of the body. Then reinstall the two screws. The fit is a little tight, but the washers provide the perfect amount of tension between the drive handle and the body of the pocket driver. The tension is just enough so that when you hold the drive handle vertically the body will stand out at 90 degrees without any support. M6 304 Stainless Steel Flat Washers, 100pcs 6x10x0.2mm Ultra Thin Flat Spacers for Screw Bolt, Electronic Repair, Automotive

[@MattGriffo]

Thanks! This is super helpful

[@Cheftrent]

It looks even better than i thought! Mine wont come for a month or so

[@TheOpinionarium]

It really is astounding

[@bScout.mtb.dt.4555]

Watch looks too tight. Is your arm ok?

[@TheOpinionarium]

The watch is fine, I can get two fingers under it. Looks bad I’ll admit though, I have really large hands and my wrist thins down a lot right before it gets to the hand so it’s comfortable. Thanks for the concern.