Check out the Nitride here: www.amainhobbies.com/elceram-nitride-1-10-brushless-lcd-display-esc-elcnitride110/p1531651
@connorclark854111 ай бұрын
Should make a 1c version for carpet oval class to
@never-stock-rc296811 ай бұрын
Imagine castle did this with a 12s esc. Next level
@maltesrc11 ай бұрын
That’s sick ❤
@LegendsPizzaCo6 ай бұрын
Can't decide on this esc or the G2S. I already have the hobbywing ota programmer so the programming isn't an issue for me
@TheCaliforniakid729 ай бұрын
put this esc in my b6.4 it is money !!!! 🏁🏁🏁
@AMain_Hobbies_29 ай бұрын
Great, happy you're lovin' it! -Brett
@LegendsPizzaCo6 ай бұрын
I have a B6.4 as well. Was deciding between this and the Xr10 G2S. I have the ota programmer already since I run hobbywing esc in most of my cars. I cant decide which to buy. On one hand I trust hobbywing and their products. They are built good and last a while. ELCeram is new to me and I can't speak for their customer service or quality od their escs. I'm torn tho cause this screen is nice to have for immediate info. My hobbywing ota gives me all this information as well just takes an extra step. Have to plug the programmer in and load the app. Its not that hard nor does it take that long. So I'm torn between these 2 escs lol
@SuperLASTLAP9 ай бұрын
Peut on conserver les différentes courbes et informations du run en mémoire ?
@BigWillieFPV8 ай бұрын
What’s refresh rate should I set my Rx channel output for this esc?
@dirtrider8810 ай бұрын
how does trapping all the heat at the bottom help cool it off? especially when the heat is created from above???
@rocketpunchrc71435 ай бұрын
Thats were the FETs are to make room for the screen
@stevenlocke54458 ай бұрын
If motor or batt wires are cut to short or go bad cant replace