Time lapse. Iveco stralis, all filters change

IVECO STRALIS engine Cursor ; oil filter, fuel filter , pre fuel filter , air filter , air drier filter , cab filter , steering filter and engine oil change time lapse

[@reilangovender5802]

To be honest.... This saved my life, thank you 🙏

[@hgvtechuk4929]

You welcome Reilan.

[@ronaldaerongonzales3561]

Thanks man iam here in japan and always do that thanks

[@hgvtechuk4929]

You welcome Ronald, thanks for subscribing!

[@AliSmeel]

Thanks

[@hgvtechuk4929]

You more than welcome!

[@DkGrRo]

Iveco Stralis 2016 (euro6) is the addblue filter (not the prefilter) located under the addblue tank the side next to the engine? T.A.

[@hgvtechuk4929]

Yeas, it is behind the adblue tank, underneath the ad blue module.

[@tankovicstibor1885]

Hy! I have a problem I tried to change the engine breather filter at the back but i cant fit in the new filter why? Iveco stralis 500 2008 Thanks sorry for bad english

[@hgvtechuk4929]

Hi Tankovicstibor! The only thing I can suggest is have a look if the new filter has the same sizes and shape compared with the old one, try fitting the old one back, sometimes a non genuine part won't fit because some little differences, I wish I could help you better but this is all I can say to you, check if the old one can be fit back in case you are doing something wrong and after check if the new filter has any difference on size/ shape. And if there's not way, just give it back to the seller and ask for an alternative after market part, or even better a genuine one....

[@cristi878787]

Hello , un advice for my please.. my stralis 450 last day give alert about fuel filter clogged .. today changed filters but the engine not run on full power .. no alert on dash . Please give me an advice . Thanx a lot

[@hgvtechuk4929]

I think there's nothing wrong with your truck, it's probably full of faults codes on the ecm, try plug off batteries and discharge all control units shorting the positive wire with the earth for 10 minutes (with batteries off) after test drive it, otherwise with diagnostic will need erase the faults and re scan for se if any current fault is still affecting engine functions. This is all I can suggest for now

[@cristi878787]

@@hgvtechuk4929 thx a lot , i will try today

[@hgvtechuk4929]

@@cristi878787 you welcome!

[@mirkomarjanovic3234]

Hi man I need help. Water in fuel filter warning came on? How do I drain? Do I have to remove everything like this? It's hard to reach.

[@hgvtechuk4929]

Hi Mirkomarjanovic. If you want to do a quick job, just open the drain plug under pre fuel filter till only clean fuel comes out, then close it and press the manual pump till it becomes hard and start the engine. This works only if water was there recently. Most of the time the sensor gets covered by sort of green bacteria causing the same fault also without water in it, so after drain the whole fuel filter, plug off the sensor, unscrew the bottom lid, the see through one , do not unscrew breeder or sensor, clean everything, expecially the sensor,(brake cleaner does a good job), make sure you can see through, in case more water comes in, most probably the fault will be still on dash, need erase it with diagnostic machine, if this fault persist the water most probably corroded the metallic sensor parts, and need new one. If you are without diagnostic machine, try plug off any of main battery wire and bridge it with the other one for 5 minutes, 50% of the times all passive faults get deleted without problems. If you open the filter remember to make sure is full before crank the engine, if the pump doesn't work you need remove the whole pre fuel filter and refit full with diesel to the top. Let me know if you find any problem or you have any questions I'm happy to help..

[@hgvtechuk4929]

I know is hard to reach, the best practical way is with cab tilt and wheels fully steered ro the right, also because in case of excessive air on lines, you must to open the bleeder on the fuel filter top, like in the video. Don't crank the engine for too long if is not starting, the engine is heavy and the starter motor will suffer, make sure there are no air gaps between pre fuel fuel and common rail.

[@mirkomarjanovic3234]

@@hgvtechuk4929 I will try and I'll come back here to tell the tale. Thanks in advance, my friend!

[@mirkomarjanovic3234]

@@hgvtechuk4929 I drained it and error was still on, disconnected the battery and after 5 minutes the error was gone. Thanks for your help!