Andrew Markel covers Nissan TSB NTB10-009b and the strategies for removing seized oxygen sensors in downpipes and exhaust pipes. Brake & Front End Magazine: www.brakeandfro... Nissan: partsadvantage....
Пікірлер: 25
@jimwilliams5565Ай бұрын
Spray on liberally pb blaster the day before. Next day warm up the cat then spray on more pb liberally, then bang the sensor with happier several times. Do that three or four times. Sensor will loosen up now. I used the o2 sensor wrench available for free use from autozone.
@Kid_Kootenay4 жыл бұрын
Ahhh hell why didn't I think of removing the exhaust 6 heat seized most likely to snap and cutting the pipe sure sounds easier that other in position ways 😂 😂 😂
@yourlocalalexis45783 жыл бұрын
lol
@JohnSmith-xx1lx3 жыл бұрын
I had no room to get any leverage, tried 02 sensor tool hammer and everything else. However discovered the amazing air hammer with the tie rod separator connector. Wouldn't recommend anything other than it only thing that could get the job done between that PB blaster.
@drew-shourd2 жыл бұрын
The one reason I clicked on this was to hear about the special split socket wrench that he picked up, but never talked about.
@maineshire2 жыл бұрын
Typical manufacturer tip. "Remove the pipe and work on a it at a work table"🙄
@fredjones12382 жыл бұрын
75 % of the time if the sensor is seized the threads in the bung are done even if you use a chaser , if your lucky grind down the top of bung to get to good threads run a tap to clean , i have had luck this way
@rog8285 Жыл бұрын
Il pay a machanic $100 to get the job done. No headache for me
@anglegrinder46303 жыл бұрын
Everyone else gets in there and does it,I guess telling you tips like 10° in 10° out is good too,I'm gonna try that right now
@mutley748916 Жыл бұрын
Looks so easy to do when it's Al on the bench and you just talk about it 🙄
@zerozero19443 жыл бұрын
Why would anyone still try to use aka leverage after the pipe was taken out vs using an impact n some inductor or heat or pb blast or combo
@seanoberbichler17262 жыл бұрын
First thing I do is ask . Politely. Lol
@bonkeydollocks18792 жыл бұрын
What's a Neeson?
@rfcdgaf2 жыл бұрын
0:34 Natural enemy of technicians, lamo
@seancomerford57243 жыл бұрын
What the hell is a TSB
@MattB903 жыл бұрын
Technical Service Bulletin, it is usually a technical message delivered by the manufacture on how to work on some particular part or informing about a problem with a part, so I didnt understand his use of it here lol
@351cleavland3 жыл бұрын
Tricky Son of a Bum.
@bonkeydollocks18792 жыл бұрын
The sh*t bro
@IM.B4 жыл бұрын
This sux, only talk.
@emojidinosaur73002 жыл бұрын
is he a beaver?
@JohnSmith-xx1lx3 жыл бұрын
By the way you look like Glenn Beck.
@yourlocalalexis45783 жыл бұрын
just order a new pipe and sensor, and charge it to the customer ,lol
@merrickmiller95293 жыл бұрын
Dont know if you guys gives a damn but if you are stoned like me atm then you can stream all of the new movies and series on InstaFlixxer. Have been streaming with my gf for the last weeks =)
@philiporlando6163 жыл бұрын
@Merrick Miller yea, been using InstaFlixxer for since november myself :)