Tips on finding hydraulic leaks and a little career advice

Рет қаралды 30,379

Junkyard HHH

Күн бұрын

Пікірлер: 15

@Kleiminc 2 жыл бұрын

Such good advice! Thank you

@basspig 3 жыл бұрын

At least you can access thus particular leak.

@yarednegede6162 2 жыл бұрын

Is there any help that my hydraulic sheet metal cutting machine is leaking some where and drop its cutting section even in power off condition.actually i change piston seals,change directional valve and i can't see any outside leak.please if you have any suggestions ?

@johncollins8304 3 жыл бұрын

I was forcing a lot of logs through a door opening in the barn, the stick being right inside. Job don, I tried to back out but the left track was dead. I heard psssss, and the top of both tracks were wet. Removed the drive panels and inside was packed solid with dry sandy soil dust and 1" pebbles almost to the top. Picked it all out, both sides filled a paint tin - - all dry, no oil. Pressure washed and left to dry. No obvious leak. All functions other than left track working. Couldn't spin the cab to lift up and access trap underneath because stick was in the doorway. Jacked up to get some sticks underneath for traction in the wet ground. Eventually I lost power to ALL functions and emptied all the hydraulics. 2008 1.5 tonne Takeuchi TB016 showing 1500 hours. Any ideas? Anyone? Thanks in advance! LGBFJB+

@Junkyardmethod 3 жыл бұрын

If it dumped the entire tank I’d be looking at suction hose or returns from motors or control valves. Had one in the shop do that after I cleaned the belly out. Stuff was packed in so tight it kept it from spewing, it would just dribble. Usually those will leak without machine running. It’ll take some digging, flashlights and mirrors but usually your finger will find the wire poking out of the hose! FJB!

@basspig 3 жыл бұрын

I had a leak under the "house" of my PC60. The lines are underbthe floor with no apparent way to access.

@JakeNBake 3 жыл бұрын

right this is the easiest leak access ive ever seen