Tips & Tricks #12 Pressed grills In a Automotive Install

[@turbogears900]

Amazing work

[@WoodDidIt]

Very good explanation bro!! I checked out the site you recommended... my question is What size/gauge material do you use?

[@nathanranghel980]

Nice video mark where can i purchase that press material.

[@MarklandDesignsOfAtlanta]

Nathan Ranghel thanks Mcnichols & AAmp global

[@nathanranghel980]

Thank you sir keep up the good work.

[@papergatorzfedducca7998]

What’s the best gauge to get to do this? I bought some from mobile solutions and it was super thick and I couldn’t get the details like you did in this video. It’s look ok but not like yours. It didn’t bend and rise like yours did. The mesh I bought is SKU: RM-MESH8 from mobile solutions. PLEASE HELP😂😂😂 I’m pretty sure it’s too thick. I had to use all my might to cut it so it could fit in my box. It’s not the right gauge. I just need to know the right gauge to order. I found another website “zoro” and “mcnichols” to order from but in order to order from them they ask what hole size, percent open area, gauge, how big, area size etc. And those are the things I don’t know. I think once I cut my rabbet in the back of my piece it’ll look a little better but it won’t look like yours😂😂😂Thank you

[@papergatorzfedducca7998]

I used a 1/4 draw/gap if that helps any.