TMAT Cargo Management System // Installs in Less than 10 Minutes // MADE IN USA 🇺🇸

[@jvogel431]

That modular bed organizer is cool. I built a slide out of a sheet of plywood. I used thin hardboard as the base under the slide and it works very nicely. I can pull the slide out far enough to reach all the contents. I built a bike rack for the slide too so I can travel with bikes inside the camper shell.

[@imaginetravelsGD]

Nice. Similar to what I did. I used small roller balls. E bikes on one side and generator and smoker on the other.

[@BuildYourOwnAdventure]

Now that's a good upgrade! LP tanks are a pain to tie down with the factory locations. Thanks for sharing!

[@WanderingWeekends]

So far so good!

[@therealjonwsmith]

Was just looking for a review, thanks. Being in snowy Michigan, I have sandbags and other stuff sliding around the back of the truck. This fits the bill nicely. We have a little snow if you are heading back up snowmobiling, but who knows if it will melt by then. 😆 Merry Christmas!

[@napes65]

I've seen the T-Mat pics on a gooseneck setup where they just leave out the square sections over the ball area and chain areas. Do you think it would be an easy and good option to just cut round holes right where I'd need it?

[@WanderingWeekends]

I think you could possibly use a jigsaw to cut the squares. That would look clean!

[@gwwj]

I've been trying to figure out a system to load my ebikes under my camper shell. I think this fits the bill!

[@WanderingWeekends]

I think they’re developing a bike mount.

[@timf6916]

Nice looking 👀

[@WanderingWeekends]

You’re awesome Tim. Always willing to engage. I really do appreciate it… even if I am better looking than you. 😜😜

[@timf6916]

@ hehehe

[@Lastcall115]

Thats a nice system and good review. How bad do you think it would scratch the paint overtime with no spray in liner?

[@WanderingWeekends]

It would scuff it up some. Also depends on how much weight you’re moving around. I can’t imagine it would ever gouge anything though.