To Fix Exhaust Muffler Leaks with JB Weld

[@michelleciardullo9461]

Best video ever 🙂 Straight and to the point! Not 20 minutes of "blah, blah, blah" 🙄🙄🙄

[@infosourcesunlimited7351]

Thanks for kindness.

[@alweenrvain2358]

I agree!!!

[@tru1655]

You meant straight to the ground? Barely showed it.

[@nameredacted1242]

Idiotic video. Curing not shown. Nothing explained.

[@miasoculpa8490]

The results matter too. I would put in on thicker.

[@timryan2058]

Gotta put it on thicker. Will last 6 months maybe.

[@ralphwhitaker8761]

Can i use it to seal the broken pipes together

[@ultimacctv]

Thanks for sharing!!!

[@gabebeltz845]

Does it hold up?

[@Ry77x]

No

[@mspeedm5849]

there is a difference between MufflerSeal Muffler Cement by JB Weld and this product shown here called MufflerWeld Muffler cement by same company. they are not the same product

[@jessedover6175]

It needs to go on thicker , NOT "paper thin".🙄

[@chucklucas8747]

Will it work on the exhaust modifold

[@justinbieber12373]

Cannot believe it did not work, cracked like plaster and fell off.. 😪

[@nameredacted1242]

Try reading idiotic instructions first. Regarding curing. Which is poorly explained. And I guess that you must remove the scale.

[@Panman-fishing-Venture]

Will it work on motorcycle exhaust? Thanks for the video and your time

[@alb12345672]

its temporary. Maybe fiberglass tape or metal mesh will buy some more time.

[@tommccallan8802]

I use tiger patch on my xr600 works really good

[@vladimira6241]

perf, great video. rattle can it black and shell be clean!

[@murhafsukkar9555]

They say “use it with water” which I was looking for! and “let it set for 30 min then run the engine for 10 min. So what the HECK I’ve just seen 🙄

[@roberttaylor1584]

Does this stuff harden like other jb weld products? Also, what is the psi? Thanks in advance!!

[@infosourcesunlimited7351]

It is hardened as other JB products. Guess 600-800 psi and up to 700 F resistant.

[@familyfirst7027]

Does this stuff really take 24 hours?

[@bgpautomotive]

@@familyfirst7027 I used a heat gun to speed up the curing process but didn't use enough, so I will be doing a second coat.

[@sergioalvarez8637]

Shit doesn't Work just use jb weld original

[@Mason-Dain]

Does not waste time and money only last for 3 days

[@drsnowmon]

J-B Weld 37901

[@spookshow6999]

You’re supposed to run your vehicle fir 10 minutes or even more after you put it on.

[@nameredacted1242]

Or use a hair dryer to heat it up.

[@infosourcesunlimited7351]

For your reference amzn.to/3gKsNUF

[@jamesmcpherson1218]

You doing a video you don't even say nothing.