HOW TO USE A G10 COMMAND TO LOAD WORK COORDINATES FROM YOUR PROGRAM

[@bikefarmtaiwan1800]

Very clear and helpful! Subbed!

[@jonathanmota8887]

how does this work out when working with stock say castings which can be sometimes over size up to an inch in any direction? This seems to be maybe a crash maybe?

[@steelcapthunder]

Can this method be used on a lathe for Z and C work offsets?

[@praveenkumarhota7570]

Yes

[@sellenger]

Love the these vids !!

[@RICREYNOLDSMUSIC]

I started a new job on some Horizontals and they are using G10 on all the machines. The problem is that if you have to rerun a sequence, you have to manualy/MDI the G10 start up program so you don`t scrap a part. These are military grade parts and I think there is a way to have the program reload the G10 numbers so it doesn`t scrap the part. Is there a way to safeguard a program to load the G10 lines before every sequence? They told me it is not possible.

[@muhndkalil9234]

Hi, I have qeustion . when I start the machine the will go to the limet switch and set it home the and when I put work pics in the table of the machine I shoud to make another home position to the work pics in the edge of the work pics the qeustion is when I have G10L2 P1 X5Y3Z4 this cordinate value will add to the first home position of the machine or to the home position of the work pics???

[@danielmckeever8241]

I use G10 all the time to load tool offsets. For Example, my driven tools for a particular job: G10 P10002 X -300.000 R 10.000 Q0. G10 P10003 X -300.000 R 5.000 Q0. G10 P10004 X -300.000 R 3.000 Q0. G10 P10005 Z -40.000 R 0.750 Q0. G10 P10009 Z -40.000 R 0.000 Q0. G10 P10010 Z -40.000 R 1.250 Q0. This prevents the machine setter forgetting to manually input the non-probed geometry values. (I've done it) My CAM package always outputs work offsets like this: G10 L2 P1 etc etc G10 L2 P2 etc etc G11 The manual says G11 is Programmable Data Input Cancel. My question is why should I use G11? If I don't use G11 the data still goes where I want it, and no other data is stored or overwritten until I manually change something or run another G10 line. In which case what's the point of G11? Why do I need to tell the NC that I'm finished inputting data? The data input is finished so I just drive on. Just curious

[@EkAdivasiraj]

Please make videos on L20

[@Lacika19810507]

Thank you