Рет қаралды 1,989
The manufacture of the holder of the tool holder of the Schaublin-90 lathe and its use are shown.
I invite you to watch other videos on my channel in playlists
"Schaublin machines (SCHAUBLIN)"
• Станки ШАУБЛИН (SCHAU...
“Lathe MN-80. Modernization":
• Токарный станок МН-80....
"Watch lathe T-65":
• Часовой токарный стано...
"Machines. Repair and improvements. Modernization":
• Станки. Ремонт и дораб...
"Tool. Tool sharpening":
• Самодельный инструмент...
"Products from balls. Working with balls»
• Изделия из шаров. Рабо...
I invite you to my channel:
kzbin.info_videos?ar=...
URL of this video:
• ФИКСАТОР резцедержател...
In one of my videos I showed how I made a tool holder for this machine
"Homemade CUT HOLDER SCHAUBLIN-90 lathe":
• Самодельный РЕЗЦЕДЕРЖА...
Now I made a 4-position latch to it.
The presence of a latch simplifies the manufacture of several identical parts when turning them with several cutters.
If there is a latch, it is enough to set up the machine for one, first, part using a measuring tool, and sharpen the rest of the parts along the dial, now without using a measuring tool.
This is illustrated by the example of turning four stepped rollers. Everyone had to grind a diameter of 17 mm minus a dozen and cut it off.
The spread of the diameter value was only two hundred parts.
Shown how I made this holder for the tool post.
I drilled a hole in the tool holder, machined the latch itself and the cork for it. I milled the grooves for the latch in a special lining for the tool holder.
The made latch simplifies the manufacture of several identical parts when turning them with several cutters.