Toothpick 2S FPV Micro Drone

[@sklepa]

nice, cant wait to build my own 2s one

[@munsie888]

Good luck my dude, careful when soldering and removing motor connectors, I would recommend wiggling off the motor connector housing then using a decent set of flush cutters to snip the three pins off flat and solder over these. I've lifted pads by trying to desolder and pull the motor connector pins outs. Also zip tie that xt30 lead as the power pads rip off easy too!.

[@davehayes5766]

Awesome flying, super smooth! Love the orbits👍

[@PanosMesi]

Hey nice video! Is there a difference with the 62.46mm antenna?

[@munsie888]

Thanks! This is from the kababfpv.com build guide: "Unfortunately these darn whoop AIO boards have fake Rx’s on board so the Rx performance totally sucks. This is a way you can at least make it more consistent and get some more range. Find a thin wire covered in silicone or a thin copper wire with an enamel coating. A 1/4 wavelength of 2.4GHz is 31.23mm and that’s how long the antenna it comes with should be. Cut your new wire to 62.46mm or as close to it as you can get. Replace the stock antenna with this new wire. Make sure the wire has no kinks in it while you’re flying. This mod makes the range just barely tolerable…"

[@sklepa]

Easy peasy dude, i have ninja soldering skills, its my daily bread kinda