Top 5 Thermal Inspection Points on an electrical motor - discovering energy waste

In this video, the top 5 thermal inspection points on a motor are shown. Discover energy waste with Fluke Thermal Imaging Cameras.
-----------------------
Michael Stuart uses thermal imaging to inspect a common electrical motor for issues that might be impacting energy usage:
1. Windings and general heat pattern
2. Termination box/ juntion box opened up, all electrical components (following electrical safety practices)
3. Convection cooling fan, if present;
4. Bearings, where not blocked by cowling covers or fans (drive-end and non-drive end)
5. Couplings/ shafts/ drive belts
Learn more about Fluke best practices: www.fluke.com/en-gb/learn/bes...

[@jadoabad]

Great training, professional presenter. Thank you so much.

[@user-kg6yf8qz7m]

i never thought about checking of junction box....but it really nice idea

[@o-techtips3871]

Nice tips

[@virtualtreadmillwalknature1488]

Well presented

[@sohailjanjua123]

Hi, I like your video. Thanks

[@sprasannaatsjec]

Hello How to mark delta temperature between two points in smartview software?

[@mehtabhashmi2009]

Thanks for the information. Sir can we used thermography for underground electrical wires ??

[@alihasan3587]

Which 4 side we should do Thermography of motor?

[@manuelalvarez5512]

Good to know

[@nj5331]

very informational video . Please could someone tell about vibration test as the person in the video mentioned. Is there any vibration analyser by fluke?

[@nickcsuki8123]

Don't know if you're still interested after 5 years, but we've recently done a vibration analysis.

[@MINHAJUDDINKhan]

was the acceptable lux level checked. was any consideration done for any source of reflection

[@rabehsai3102]

You should do this work for a case have really pb to understand

[@user-hu4if6xw8p]

What is the maximum value of temperature for motor

[@tatjanastefanova1467]

Why the emission coefficient choosed 0.95?

[@tejeshwssl6295]

try EXTECH vibration meter

[@ahmedzuhair4474]

21/12/2021

[@peterbennett8810]

you stated the temp. is good, but did not say why. what was the motor manufacture's specs?

[@fyuecd2]

I thought you were supposed to remove the load before you do your testing.

[@TriPham-xd9wk]

l

[@phasorsystems6873]

Are your teachers busy? pursue androidcircuitsolver on google