Top Festool MFT Accessories

[@warrensmith2902]

Heard this tip from someone else on web and it works. Try using a 2' x 2' of 3/4" square of MDF sheet goods. Most big box stores sell them for cheap as a project board. Pick one that does not have destroyed edges. It gets me to within cabinet square tolerances for setting up my MFT/3 with a touch of sanding of a few high spots. I usually find the squarest corner with my machinist square, then cut a diagonal to give me a lighter triangle at the end of one of the legs from that square corner. A quick cut off of the corners of the triangle and you should be good to go. Once the table is set up, I put it away so the edges are protected, till I start my next project, and I check again for square before starting. This usually passes the 5 corner test for square with a woodworkers needed level of accuracy.

[@NBGTFO]

DashboardPWS rocks! I regret I bought the Festool MFT/3 before I found out about the Dashboard PWS.

[@robertschumacher1787]

It might not be too late. We hear there's a thriving market in used MFT/3s.:)

[@BuckRogers2491]

The Dash-Board from Rob is awesome. I have what you're referring to as the older version (black and silver) and I'm no longer frustrated when I have to change the guide rail bracket height. BTW, the setup square from Woodpeckers, if it's the one I'm thinking of, is phenolic.

[@tiagojesuspassos8531]

Hello my friend, send me the purchase link for the Festoll work table

[@Micha_Ba]

Site of Utility rack can't be found 😢

[@xinixxagnix201]

Sloppy holes for the standard 19.90 benchdogs, you need 19.98 mm dogs.

[@mikeking7470]

WHERE are 19.90mm dogs standard? My dogs all measure either 3/4 inch (Workmate) or 20mm (Bora and Festool MFT).