More useful videos about Skoda Yeti reliability: kzbin.info/www/bejne/rofUp56parJ-rc0 kzbin.info/www/bejne/gnzOmYqMf5lksKs kzbin.info/www/bejne/qGalqKNreNOnb7c
@Xenon777_ Жыл бұрын
We have a 2012 1.6 diesel Yeti with 100k miles and have only ever had a few issues. A glow plug broke and the passenger door wiring harness (frayed wires). There was also an issue with the paper / card packer in the steering wheel - it fell apart causing a crunching noise when steering. Other than that, just the usual consumables such as a wheel bearing.
@lumbrs Жыл бұрын
I own 2.0TDI (180hp) 2012 fwd, 5 speed manual, for 6 years. Issues so far: *Issue with drivers doors cables. Place where it bends - broken airbag sensor wire. *Rust between doors, on both sides. Fix it asap! If you see any rust or paint bubbles, fix it asap! *Fr R spring coil broke. *Clutch started to slip at 260k kilometers. Due to chip tuning. Slips on 3rd and 5th gear. But in general - good car.
@Xenon777_ Жыл бұрын
Our 2012 one also rusted on the bottom corners of the doors. They also can rust behind the rear number plate so it might be worth checking before it's too late!
@lumbrs Жыл бұрын
@@Xenon777_ checked behind number plate. Rusted as hell!
@Xenon777_ Жыл бұрын
@@lumbrs Our had to be patched up by the body shop as it was rusted that badly.
@dorianmanto751311 ай бұрын
The 5 speed manual version should not be chip tuned as the transmission is weak already and limits the torque of the engine from the factory.
@abhayapte7226 Жыл бұрын
I own a yeti 2.0 TDi 4X4 ( 2011) the only 2 problems i have faced so far are constant ABS /TRACTION CONTROL sensor issue. resolved after a reset/ replacement of the faulty sensor. Also recently am facing an issue of a creaking sound after starting the vehicle ( RUBBER ENGINE/ OTHER MOUNTS??) but the sound disapears after a few minutes Appreciate any feedback....
@prasanthkoyyyot46453 ай бұрын
Thank you. On scanning no wiring fault found
@billchalke3085 Жыл бұрын
Just had first brake pads 100200 miles other than that no problems
@keithnewton89814 ай бұрын
1.2 tsi engine dropped the timing chain in 2015 it a belt drive now
@PrasanthMK-i3l4 ай бұрын
I have a Yeti 4x2 2.0 TDI changed timing belt and water pump after 50000 km. Now temp gauge not working. When scanned, it showing P0118 coolant temp fault. One of the mech advised its because of ECM issue. Confused! Everything else fine. Even emission normal. No dark smoke.
@65scottiedog3 ай бұрын
Check your wiring plugs as it was ok that my thoughts
@tarquinfintim5910 Жыл бұрын
I have to say this, please get someone with good english pronunciation to do your voice overs. I had to replay so much of this video because what I heard didn't make sense, I then had to think of the word you were trying to say before I could continue. Very distracting. Sorry :)
@JLongTom Жыл бұрын
I disagree --- not a single word was hard to understand for me. Super informative video.
@murphyandmurphybrand Жыл бұрын
I Understood it clearly too.
@alekSrbija9 ай бұрын
@@murphyandmurphybrand many of you did, but many of us didnt..
@murphyandmurphybrand9 ай бұрын
@@alekSrbija go find another video. He has perfectly good pronunciation so why should he find or pay someone else to voice over just for a few people who don’t want to take the time to understand him.
@kostaskoko38852 ай бұрын
two engine revamps withn 140.000 km and two intercooler failures at a 1.2 112hp 2009 yeti. what a crap car
@grahampilkington252 Жыл бұрын
Hard to follow this review. Changing from one engine to another at 100 mph speaking.