鉋の利用２/３ 角材を削る Planing a square wood

鉋シリーズ第3弾　鉋の利用（実践編）２/3「角材を削る」
鉋刃の研ぎ、鉋台のセッティングとメンテナンスに続いて、鉋の利用方法を３つの動画で説明します。その２つめ「角材を削る」

[@kaytarner8381]

すべてのビデオがありえないほど貴重な知見に富んでいます

[@joseghpax2496]

確かに、電動は刃が木を叩いて押し付けますね・・・

[@mauroplatania236]

Compliment for video tutorial 👍

[@tkcgf]

仕上げた面は表面が輝いてますね、すごい

[@juliuscaesarkammel5752]

Muchas gracias por su tiempo compartido. Saludos desde el Sur de Chile.

[@ВиталийВойтович-д9э]

Thank you very much for the video. I wanted to ask you, 1) Is it possible to sharpen a planer blade qualitatively-using artificial stones-in turn-800 grit, 1000 grit, 6000 grit and 10000 grit. 2) And I also wanted to ask you - after each stone you need to remove the burr - or do you need to remove the burr only at the end on the finish stone? Thank you very much with respect, Vitaliy.

[@estudiohayabusa]

1) Of course you can sharpen with that if stones and you will get amazing results, no need to use Japanese natural stones always. 2) If the burr is too much large because you used a course stone, then it is better to take it off before passing on the next finer stone. If you create a reasonable burr in 1000 grit stone, then you don't need to take it off until the last and finest stone.

[@大石規義-i2n]

なたね

[@ManishYadav-hv6tn]

English subtitles is expected in this channel

[@georgesikonomou3895]

i would be very Grateful if you could put subtitles

[@mnldgbD]

Georges Ikonomou pleaseeeeeeee

[@juginstr1019]

Thank you for the Wonderful video.Good luck.

[@totosann29]

昔は一枚刃の仕上げ鉋が普通だったけど、

[@vfd1938]

鉋が削る木材に対して平行ではなく少し傾いているのは何故ですか？削りやすいとか、癖とかで平行に引いてはダメですか。

[@luffy426]

角度がついてる方が切れるからですね

[@vfd1938]

@@luffy426 鉋の削り大会に行くと斜めに引く奴は素人と彼方此方で言われたので聞きました。

[@joaocarloscubasdesouza8596]

Muito bom aprendi muito obrigado