Traxxas revo with dynamite big red .28 with traxxas big block mount and traxxas big block header and ths small block pipe upgrading to big block soon rwd conversion with locked rear diff proline tires
Пікірлер: 19
@213madd92 жыл бұрын
Whats the new era mount?? Anyone have a part number? Can you show your starting set up? I wanna do this swap, need more info.
@englandstillhasit10 жыл бұрын
Very nice welcome to the revo club have a look at mine it's almost full mod I have the new era but waiting till my picco 26 dies before replacing it but my new engine choices are the big red or lrp28 s3 I do have a think for anodized red right now tho. I have the rc solutions roll cage and I'm worried my exhaust will foul on it I hope not tho but ide rather sell my cage than not carry on with big block. I paid $150 for the steel gears to be safe and won't let that go to waste lol. Have you got the rrp gears in this I would hate to hear plastic hold up fine. My diffs are the weak link now and centre shafts but I plan to run them to destruction then get some Mips centre. Keep uploading man and talk it's hard to talk to a camera trust I know just watch me stutter and forget what I want to say but stuff it who cares as long as wer learning new revo tricks. Peace.
@jose11221j9 жыл бұрын
I have all plastic gears I drove the truck about 6 to 7 tanks off feul ran perfect I now took it apart to change the spear gear thats the only thing that got destroyed only cost under $10
@ERLJR828 жыл бұрын
how are you starting truck?? A bump starter? I have installed engine but can't find a New era mount
@dustinstacy876310 жыл бұрын
That's really nice how did u get your header pipe to connect so close to your exhaust port did u take off the rubber seal
@jose11221j9 жыл бұрын
I used the traxxas big block header it was tight just force it a little fit perfectly
@rodrigoalvarado47759 жыл бұрын
jose11221j is it a direct fit or u need different engine mount looks nice
@jose11221j9 жыл бұрын
Rodrigo Alvarado traxxas big block Mount
@nitrotime66908 жыл бұрын
can u drive it with out the pull starter
@MissRiver704319 жыл бұрын
I have the Dynamite Big Red .28 on my Revo 2.5. I have one question for you as Horizon Hobby cannot answer. To make it fit I had to remove the Pull/Spin start housing on the back of the engine which leaves the exposed bolt head. Is it drivable without the Pull/Spin mechanism installed.
@BJnCars4 жыл бұрын
I want to do the same how did it work? Does it mount right on, does it fit the transmission?
@jeffklimek33883 жыл бұрын
Starter?????????
@jose11221j3 жыл бұрын
Jeff Klimek power drill or bump start
@mrsideways45746 жыл бұрын
They sell a back plate I’ll put the link in comments in a few
@FUNGU56669 жыл бұрын
Hey man what mount is it THAT and did you have to mod the chassis at all im planning on using the same motor
@jose11221j9 жыл бұрын
I used the traxxas big block mount but u dont need to modify anything just buy the traxxas big block mount but with this mount u can only start the engine with a drill or some type of starter Im using my drill to start it I recommend the new era mount
@FUNGU56669 жыл бұрын
Yeah I just can't font the new era mount any where you know wherein could find one
@jose11221j9 жыл бұрын
Chris Stanley I saw some on ebay but u need to be on the look out they sell really fast and thank you for watching my video