secret angle iron cutting techniques|cutting to make frame

the following is the||secret angle iron cutting techniques||this method will be easy to understand, especially for beginners welders||secret angle iron cutting techniques for beginners||cutting to make frame||how to cutting and welding to make frame.

[@ZOLDAIOQUE88MADACI]

I like the way you weld ... amps setting please?

[@trickswelder3839]

Thank You, setting the amperage at 80 amps

[@maestroamonathan4279]

what your welding rod size

[@moein.sh7033]

Pp😂ppppppp😂pppp😂pppppppppppppppppppppp😂pppppppppppppp opportunities ppppppppppppplpppppppp@@maestroamonathan4279pppppppppp oppp pppp😂pp

[@SonuKaler-c1l]

Bhai rode kitne num ki lagdi hai

[@robertcoyle1532]

So the 'secret' of cutting angle iron is to use the 45 on a square????

[@brandonlarsh6416]

What were the secrets you were trying to show us how not to weld don't know where you learned to weld but that is definitely not how you want to weld anything

[@trickswelder3839]

🙏

[@dikuharsh]

Secrect angle iron cutting techniques cutting to make frame

[@TrendyFlix-sr4gq]

Thanks

[@trickswelder3839]

🙏 you're welcome

[@nelsondelossantos5424]

What sitting or ampere welding machine?nice welding

[@oscarherrera9049]

Which welding stick did you use?

[@trickswelder3839]

Welding stick e 6013

[@thorstenschwientek4182]

I'm searching for the secret 😂

[@Mike-ix6cd]

Класс

[@trickswelder3839]

🙏👍

[@petermoses5095]

Waste of time .and u need to learn how to weld before u demonstrate lack of knowledge to others

[@trickswelder3839]

Thank You

[@imretoth2341]

hu ez a pötyögtetés ez nem hegesztés,normálisan az ampert beálitani ,és lehet folyamatosan hegeszteni,nem gányolni csak👍🤣idióta🤣👍

[@trickswelder3839]

Ok

[@tyrotrainer765]

Try a continuous weld on thin sheet like car panels.... You'll destroy the panel. They use spot welding all along the joint to prevent blow through and distortion. Tacking is a valid method for metal that is not load bearing and appearance is important. There are so many welding know all on here. I'm going to make some small plant holders for my garden from 3/8 square tubing...... DO you think I'll waste my time running beads on that stuff? Thank you for the video, it was good revision for me because I have not cut angle iron frames in a long time. I have given thumbs up.

[@arefzobeidy4025]

کشخااوکی