Tried To "Blow Out" The Dents In The CR125R Pipe

[@gime3steps]

I still have a plate i made for the inlet tapped for a air chuck fitting, worked really good, uses the 2 bolt exhaust clamp and a piece Of innertube for a seal

[@restoroosterohv]

How did you block the small end?

[@chopfather2730]

Mab too late ....but try a cap with a worm drive clamp .instead of the clean out plug.....peace!

[@restoroosterohv]

Thanks for the suggestion. I don't do this too often but if I did it again, I would get the proper clamps. It's already a pretty dangerous procedure.