Triumph GT6: Passenger floor corner part 4

[@drivewayshop]

Looks like it will work. Nice job!

[@DavidPlass]

Thanks!

[@redfoxclassics]

Looking good! Yeah, the rot you highlighted at the end is not typical, so as you say something must’ve caused water to accumulate there. Would you mind giving me the measurements from the lower seat belt bolt on the wheel arch to the seat pan and spring tunnel in the area you just repaired? I’ve just drilled that hole in my car, and I’m curious how close to the stock position for the later cars it ended up!

[@DavidPlass]

Do you mean to the "occasional seat" ("rear seat") pan?

[@redfoxclassics]

Yeah. The occasional seat pan. The two faces you’ve welded your panel to in this video.

[@DavidPlass]

On my LHD 1972, on the left side it's 68mm to the TOP of the hole.