troubleshooting laminating problems solved

[@teabagNBG]

im buiyn my prints from a shop and they actually pretty good but im not satisfied with the laminate... there always is some area where there is some kind of STRIPE across the whole sheet where it seems like the laminate isnt pressed against in the same strenght... what this could be?

[@thomasrocksit9775]

where can we buy this ? where is it located ?

[@noahwoods9916]

AGL Deforest, WI

[@as6488]

Hey David, I've been watching your videos and already gained experience. Thanks. I 've got myself into a strange issue: some very small bubbles, visible only AFTER adding the photo (printed with Canon Pro 100S - absolutely flawless and already inside adhesive film) onto acrylic! Those very small bubbles are visible ONLY if the acrylic is set into a frame with led's (all 4 sides set with 3000K led's warm white light). This is a special project of mine, printing photos to acrylic (in this case - 8mm thickness) and insert the plate into an aluminium frame with led film.

[@robertc7524]

David, are you still dealing with laminators?

[@hashimbaloch3760]

Good job👍👍

[@goetterdone]

Thanks Hashim

[@Mr_Chuckles]

Superb