How to Replace Radiator 1994-2004 Chevy S-10

[@TRQ]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*

[@robertholiday1046]

You don't have to remove the fanclutch unless replacing the water pump Good video informative yet not cheesy

[@lukel3260]

Straight to the point. Short and simple. Great video thank you

[@glennredwine289]

this was a 4.3V6 vehicle, right? It sure is nice when you have the correct tools. And looking at this truck and remembering my own old 2000 blazer reminds me how nice it is to work on my 95 Dakota V6. it cavernous under there, unlike GM where they fit everything in with a shoehorn.

[@TomStedham]

I just noticed that the heat/AC dial is literally the opposite of what is in my 2002 S10. On my truck, heat (red) is to the left, and AC (blue) is to the right. In this video, at 5:48, it's the opposite. I did a double-take, and I actually walked outside to my truck, to make sure that I wasn't hallucinating. lol...😅

[@ganjalfcreamcorn8438]

Hello, do you have to drain transmission fluid and oil before you do this?

[@richiesflicks]

Can it be done without removing the fan?

[@Swoledaddy]

What’s the tool used to remove the fan clutch you had on the impact

[@richardd9955]

Special tool maybe available at an Auto Zone or NAPA

[@sketchysquad9614]

How soon can you start the car after putting the new radiator in?

[@richardd9955]

What type of tool was used for fan bolt attached to fan clutch to include extension

[@TRQ]

+@richardd9955 A fan clutch wrench was used.

[@pbv61]

My intake opening partly broke. I have enough room to splice on an extension. I tried using epoxy but eventually worked look. Do you know what kind of plastic is used on radiator? Is it PVC or ABS?

[@hermanv450]

What the tool call to take off the fan?

[@you-nh8xo]

After disconnecting everything from the radiator, does it just pull up?

[@boomernyob4930]

yes

[@Njennings42]

I can't get to my lower oil/transmission lines as the lower fan shroud is in the way, suggestions?

[@trailkingsmx1609]

What if you dont have that tool for the fan

[@N3PZZ]

Just be extremely careful removing and replacing the radiator. I don't have that tool, but it'll work fine without it. Just take your time and be patient.

[@ilopez6208]

Awesome video

[@johnmoyse52]

U gorgot to put the rubber bushings back on the top of the rad

[@anthonyswift5521]

I didnt take those Rings off. Is that bad?

[@cgreen339]

What is that tool!!!! Gosh darn it you!!!!

[@N3PZZ]

Fan clutch removal tool

[@gandhysanchez6986]

Thanks!!!

[@EddySmith85]

Make it seem so easy lol Those little clips are the desth of me lol ugh