Trying To Reach Some Hex Fasteners Can Be Tough! RBRT Speed Hex To The Rescue!!

[@georgeferlazzo7936]

Hello again, Dan Thank you for another Great Video 👍 It's always great to hear more about RBRT tools. Again thank you 😊

[@purrunit4360]

I think the technology behind these hex bits are truly game changing having said that they still suffer from the same issue a lot of other medium- long hex sockets suffer from which is the fact that when you buy say your 3/8 drive rbrt non ball end hex sockets sure they can give you the extended length of reaching down “to” something but what happens when you are dealing with a hex bolt that is recessed down in a hole, once you get a few sizes smaller then the actual diameter of the hex shaft that is the same on all the sockets (not the actual tip but the shaft that connects to the socket itself) it doesn’t fit in the hole, a huge improvement would be to either make the shaft cylindrical or decrease the size to better match the actual tip size.

[@dantherbrtguy6571]

I am going to speak to the team about this, thank you for the insight.

[@SPMech1]

👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍

[@oldman3388]

Most people would just take the carb off or use a bit with small wrench if they have a long ball socket it pays to have the right tool for the job. 🔧🔧🔧🔧